Downfall

# Downfall with AMD Ryzen 5 5600G + NVIDIA GeForce RTX 3070 Ti

The AMD Ryzen 5 5600G paired with the NVIDIA GeForce RTX 3070 Ti delivers a broad spread of frame rates across Downfall's four settings presets, ranging from a floor of 50 FPS at 4K Ultra to a ceiling of 270 FPS at 1080p Low. This combination places 1328th out of 3716 tested combos in the game, putting it in the 64th percentile of all system pairings — a solidly above-average result for a horror title that rewards high refresh rates as much as visual fidelity. The data reveals a system that is GPU-bound at higher resolutions but increasingly CPU-limited as resolution drops, with the Ryzen 5 5600G's six Zen 3 cores and 16 MB of L3 cache becoming a more significant factor at 1080p.

Resolution Scaling

The frame rate scaling from 1080p to 4K follows a predictable pattern that highlights where the bottleneck shifts in this pairing. At 1080p Low, the combo produces 270 FPS, but at 4K Low that figure drops to 120 FPS — a reduction of 55.6% as pixel count increases roughly fourfold. This disproportionate scaling indicates that the RTX 3070 Ti is not yet saturated at 1080p; the Ryzen 5 5600G, with its 3.90 GHz base and 4.40 GHz boost clocks, is likely limiting performance at lower resolutions where the GPU can render frames faster than the CPU can feed it.

Moving to the Medium preset tells a similar story. At 1080p Medium the average is 221 FPS, while 1440p Medium drops to 158 FPS and 4K Medium sits at 98 FPS. The step from 1080p to 1440p costs 28.5% of performance, while the step from 1440p to 4K costs another 38.0%. This progressively steeper decline per resolution tier suggests that the GPU begins to take over as the primary constraint once pixel throughput demands increase, with the 8 GB of GDDR6X memory and 608.3 GB/s bandwidth becoming more relevant at 4K.

High settings show the most linear scaling of any preset. The 1080p High average of 181 FPS drops to 129 FPS at 1440p (a 28.7% reduction) and then to 80 FPS at 4K (a 38.0% reduction from 1440p). The consistent pattern across Medium and High indicates that these presets are well-balanced for this hardware, with neither component becoming a severe bottleneck until the extreme end of the resolution spectrum.

Ultra settings reveal the sharpest drop. At 1080p Ultra the combo manages 113 FPS, which falls to 81 FPS at 1440p (down 28.3%) and then to just 50 FPS at 4K (down 38.3% from 1440p). The 4K Ultra result of 50 FPS is the only measured average below 60 FPS across the entire dataset, making it the sole configuration where this pairing fails to maintain smooth gameplay. The scaling pattern across all four presets — with 1080p to 1440p costing roughly 28-29% and 1440p to 4K costing roughly 38% — indicates that the RTX 3070 Ti's 21.75 TFLOPS of FP32 performance and 169.9 GPixel/s pixel rate are the governing factors once resolution climbs, while the CPU's influence fades accordingly.

Settings Recommendations

The measured data provides clear guidance for prioritizing settings based on resolution targets. At 4K, the choice is stark: Ultra produces a 50 FPS average, which is below the 60 FPS threshold many players consider minimum for smooth play. High settings at 4K deliver 80 FPS — a 60% improvement over Ultra — while Medium yields 98 FPS, a 96% improvement over Ultra at the cost of some visual fidelity. Low at 4K reaches 120 FPS, but the jump from Medium to Low (22.4% faster) is smaller than the jump from Ultra to Medium (96% faster), suggesting that Medium represents the sweet spot for 4K if visual quality matters more than raw frame rate.

At 1440p, all four presets clear the 60 FPS bar. Ultra runs at 81 FPS, High at 129 FPS, Medium at 158 FPS, and Low at 193 FPS. The Medium preset here offers the best balance: it provides a 158 FPS average with measured minimums of 134 FPS and maximums of 181 FPS, meaning even the worst-case frame times stay well above 120 FPS. High at 1440p is also viable at 129 FPS, but Medium's tighter min-max range (134-181 versus no reported variance for High) suggests more consistent frame pacing. For players with 144 Hz monitors, Medium is the clear recommendation at 1440p, as it sustains averages above 144 FPS while Low at 193 FPS offers diminishing returns for the visual hit.

At 1080p, the story shifts toward CPU limitations. Low produces 270 FPS, Medium 221 FPS, High 181 FPS, and Ultra 113 FPS. The Medium preset's measured range of 188-254 FPS keeps minimums above 144 Hz, making it the recommended choice for high-refresh displays. High at 181 FPS still clears 144 Hz on average but leaves less headroom for demanding scenes. Ultra at 113 FPS is playable on standard 60 Hz and 120 Hz displays but falls short of 144 Hz targets. Given that the Ryzen 5 5600G's multithreaded score of 10551 in Cinebench R23 suggests it can feed high frame rates, Medium at 1080p appears to be the optimal balance between visual quality and performance, as it leverages the GPU's headroom without exposing the CPU bottleneck that Low settings might mask.

How This Combo Ranks

The combo's rank of 1328 out of 3716 tested combinations places it in the top 35.7% of all pairings measured in Downfall. This is a strong result for a mid-range CPU paired with a high-end GPU, reflecting that the RTX 3070 Ti carries most of the weight in this game. The CPU's percentile rank of 74 against all processors — with an average benchmark score of 21088 — positions it near the boundary between mid-range and high-end, while the GPU's percentile of 75 with an average score of 29945 shows similar relative standing.

Examining the nearest rivals for each component reveals how balanced this pairing is. The Ryzen 5 5600G's closest competitor is the Intel Core i3-1220P, which scores 21066 — just 0.1% lower. The AMD Ryzen 5 7530U scores 21133, 0.2% higher, and the Intel Core Ultra 7 256V scores 21112, also 0.2% higher. This clustering within a 0.5% band means that swapping in any of these near-equivalent CPUs would produce nearly identical results in Downfall, confirming that the CPU is not a differentiator at this performance tier.

On the GPU side, the RTX 3070 Ti sits between the NVIDIA GeForce RTX 5070 Mobile (29928, 0.1% lower) and the AMD Radeon RX 6800 (30095, 0.5% higher). The RTX 2080 Ti trails by 0.5% at 29783, while the Radeon RX 6700 leads by 1.6% at 30433. This tight grouping means the combo's overall rank is unlikely to shift dramatically with GPU substitutions, though the 1.6% gap to the RX 6700 could translate to a few extra frames at 4K where the GPU is the bottleneck. The combo's 64th percentile overall ranking (1328 of 3716) aligns with both components' individual 74-75 percentiles, indicating consistent performance across the pairing.

Measured FPS Breakdown

At 1920x1080, the combo delivers its highest frame rates across all presets. Low settings produce a 270 FPS average with no reported minimum or maximum, indicating the measurement captured a stable run. Medium averages 221 FPS with a measured range of 188 to 254 FPS, showing a 66 FPS spread between worst and best cases. High averages 181 FPS, and Ultra drops to 113 FPS. The progression from Low to Ultra represents a 58.1% reduction in average frame rate, a substantial cost for the visual improvements that Ultra brings.

At 2560x1440, the averages step down predictably. Low runs at 193 FPS, Medium at 158 FPS with a range of 134 to 181 FPS, High at 129 FPS, and Ultra at 81 FPS. The Medium preset's 47 FPS spread (134-181) is tighter in percentage terms than at 1080p (66 FPS spread on a higher base), suggesting more consistent frame delivery at the higher resolution. The step from High to Ultra at 1440p costs 48 FPS, or 37.2%, which is the largest single-preset jump at this resolution.

At 3840x2160, the averages fall to 120 FPS on Low, 98 FPS on Medium (with a range of 83 to 113 FPS), 80 FPS on High, and 50 FPS on Ultra. The Medium preset's 30 FPS spread (83-113) represents the narrowest range relative to its average across all resolutions, indicating that 4K Medium provides the most stable frame pacing of any configuration. The gap between High and Ultra at 4K is also 30 FPS (80 to 50), a 37.5% reduction that makes Ultra the only preset where the average dips below playable thresholds. Across all resolutions, the Medium preset is the only one with complete min/max data, suggesting it was the most thoroughly measured configuration in this dataset.

GPU Role

The NVIDIA GeForce RTX 3070 Ti is the dominant component in this pairing for Downfall, as evidenced by the frame rate scaling across resolutions. Its 8 GB of GDDR6X memory on a 256-bit bus provides 608.3 GB/s of bandwidth, which proves sufficient even at 4K Ultra where the 50 FPS average suggests the GPU is working near its limits. The GA104 chip contains 6144 shading units, 192 texture mapping units, and 96 raster operations units, delivering 21.75 TFLOPS of FP32 performance and a pixel rate of 169.9 GPixel/s.

The GPU's clock behavior matters for this game. With a base clock of 1575 MHz and a boost clock of 1770 MHz, the RTX 3070 Ti maintains high frequencies under load, and the 19 Gbps effective memory clock keeps the 608.3 GB/s bandwidth fed. The card's 290 W TDP and suggested 600 W PSU indicate substantial power delivery, but the measured performance shows this hardware is well-utilized in Downfall. The GPU's PassMark G3D score of 23356 and 3DMark Steel Nomad DX12 score of 3478 place it in the 75th percentile of all GPUs, and its nearest rival — the RTX 5070 Mobile at 0.1% lower — confirms it remains competitive despite being end-of-life.

The GPU's role becomes more pronounced at higher resolutions. The consistent 38% performance drop from 1440p to 4K across Medium, High, and Ultra presets points to the RTX 3070 Ti's memory bandwidth and pixel throughput as the limiting factors. At 1080p, however, the GPU's headroom is evident — the 270 FPS Low result exceeds what the Ryzen 5 5600G can consistently feed, given the CPU's single-thread score of 1409 in Cinebench R23. This means that in CPU-bound scenarios at 1080p, the GPU's 48 ray tracing cores and 192 tensor cores remain underutilized, while at 4K they are fully engaged. The VRAM capacity of 8 GB does not appear to cause issues in Downfall, as even the 4K Ultra configuration maintains a 50 FPS average without reported stutter or texture thrashing.

FAQ

Q: What is the best resolution for this combo in Downfall?

A: The data shows 1440p Medium as the optimal balance, delivering 158 FPS average with a range of 134 to 181 FPS. This is the only configuration where all measured presets stay above 60 FPS, and Medium provides the tightest frame pacing relative to its average.

Q: Can this combo handle 4K gaming in Downfall?

A: Yes, but with caveats. At 4K High, the combo averages 80 FPS, and at Medium it reaches 98 FPS. However, 4K Ultra drops to 50 FPS, which is below the 60 FPS threshold. Players targeting 4K should stick to High or Medium settings.

Q: How does the RTX 3070 Ti compare to its nearest rivals in this game?

A: The RTX 3070 Ti's average benchmark score of 29945 is 0.1% higher than the RTX 5070 Mobile, 0.5% lower than the Radeon RX 6800, 0.5% higher than the RTX 2080 Ti, and 1.6% lower than the Radeon RX 6700. These differences translate to minor frame rate variations at 4K.

Q: Is the Ryzen 5 5600G a bottleneck in Downfall?

A: At 1080p Low, the 270 FPS result suggests the CPU limits performance, as the GPU could potentially render more frames. At 1440p and above, the GPU becomes the primary constraint. The CPU's 74th percentile ranking and close scores to rivals like the Core i3-1220P (0.1% difference) indicate it is not a significant bottleneck at higher resolutions.

Q: What frame rates can I expect on Ultra settings?

A: At 1080p Ultra, the average is 113 FPS. At 1440p Ultra, it drops to 81 FPS. At 4K Ultra, it falls to 50 FPS. The 4K Ultra result is the only measured configuration below 60 FPS across the entire dataset.

Q: How does the combo's overall ranking break down?

A: The combo ranks 1328th out of 3716 tested combinations in Downfall, placing it in the top 35.7%. Both the CPU and GPU sit at the 74th and 75th percentiles respectively, showing consistent relative performance between the two components.