Palworld

Palworld on the AMD Ryzen 7 5800XT and Intel Arc B570 combination lands at rank 2362 out of 2944 tested combos, placing it in the lower third of the database. That rank is heavily influenced by the graphics card’s positioning rather than the processor, and the measured frame rates confirm a system that is playable at 1080p and 1440p with adjusted settings, but one that struggles to maintain smooth performance at 4K. The Intel Arc B570, with its 10 GB of VRAM and 160-bit memory bus, delivers a 65th percentile standing among all GPUs, which is respectable for a mid-range part, yet it is not enough to push this combo into the upper echelons of the ranking table. The Ryzen 7 5800XT, by contrast, sits at the 81st percentile among all CPUs, showing that the processor is the stronger component in this pairing.

How This Combo Ranks

The combo rank of 2362 out of 2944 means that roughly 80% of tested combinations outperform this setup in Palworld. That is a sobering starting point, but the context matters: the rank is a composite of CPU and GPU capabilities, and the data shows the GPU is the bottleneck in most scenarios. The Intel Arc B570’s average benchmark score of 20556 places it just 0.1% behind the NVIDIA GeForce RTX 3070 Mobile, which scores 20534, and 0.1% ahead of the Intel Arc A750 at 20582. These are near-identical scores, indicating that the B570 is firmly in the mid-range tier for graphics processing. The CPU, meanwhile, has an average benchmark score of 29879, which is 0.6% ahead of the AMD Ryzen 5 9600X (29713) and essentially tied with the AMD Ryzen 7 7840H (29868). The processor’s 81st percentile ranking among all CPUs is a clear signal that it is not the limiting factor in Palworld’s performance.

What the rank does not tell you directly is how the combo behaves across different settings and resolutions. The measured FPS data fills that gap. At 1080p with Low settings, the combo hits 130 FPS average, which is well above the 60 FPS threshold for smooth gameplay. At 1440p with Low settings, it drops to 85 FPS, still playable. At 4K with Ultra settings, it falls to 22 FPS, which is effectively unplayable for a survival game that requires responsive controls. The rank of 2362 reflects this wide spread: the combo can handle lighter loads but falls apart under maximum graphical stress. When compared to the nearest rival GPUs, the B570’s performance is consistent with its benchmark scores, but Palworld’s specific demands—likely its open-world rendering and physics calculations—expose the GPU’s limitations at higher resolutions.

The data also shows that the combo’s rank is not an outlier in terms of component pairing. The CPU’s nearest rivals, such as the Ryzen 7 7840H and Ryzen 7 8845HS, have average scores within 0.3% of the 5800XT, meaning any of these processors would likely produce similar results with the same GPU. The GPU’s nearest rivals, like the RTX 3070 Mobile and Arc A750, are also within 0.1% of the B570’s score. This suggests that the combo rank is typical for this class of hardware, and users should expect mid-range performance in Palworld, not top-tier frame rates.

GPU Role

The Intel Arc B570 is the primary driver of Palworld’s frame rates, and its specifications explain why the combo ranks where it does. The GPU has 10 GB of GDDR6 memory on a 160-bit bus, yielding a bandwidth of 380.0 GB/s. That memory configuration is adequate for 1080p and 1440p gaming, but at 4K, the 10 GB capacity and reduced bus width become a liability. The measured FPS at 3840x2160 Ultra is 22 FPS average, which is a clear sign that the GPU is overwhelmed by the pixel count and texture data. The boost clock of 2500 MHz is modest for modern GPUs, and the FP32 performance of 11.52 TFLOPS places the B570 in the mid-range bracket, consistent with its 65th percentile ranking.

The GPU’s benchmark scores align with its in-game behavior. In 3DMark Steel Nomad DX12, it scores 2649, and in Geekbench Vulkan, it reaches 96844. These are not top-tier numbers, but they are respectable for a card with a 150 W TDP. The PassMark G3D score of 14195 further confirms the mid-range positioning. In Palworld, the GPU’s role is evident from the scaling: at 1080p Low, the combo achieves 130 FPS, but at 4K Ultra, it drops to 22 FPS. That is a 108 FPS swing, and the GPU is responsible for most of it. The CPU, with its 8 cores and 16 threads, is not the constraint at 4K, as the frame rate plummets regardless of the processor’s capabilities.

The B570’s 18 ray tracing cores and 2304 shading units are present, but Palworld does not appear to leverage them heavily based on the measured data. The game’s performance at Medium settings shows a more balanced load: at 1080p Medium, the combo averages 105 FPS, with a minimum of 89 FPS and a maximum of 121 FPS. At 1440p Medium, it averages 69 FPS, with a minimum of 59 FPS. These numbers suggest that the GPU can handle moderate settings without major frame time spikes, but pushing to Ultra at any resolution introduces significant drops. The 10 GB VRAM is likely sufficient for Medium presets, but Ultra textures and effects may exceed the memory bandwidth, causing the 22 FPS result at 4K.

Resolution Scaling

The FPS scaling from 1080p to 4K reveals a GPU-bound system. At Low settings, the combo delivers 130 FPS at 1920x1080, 85 FPS at 2560x1440, and 47 FPS at 3840x2160. That is a 36% drop from 1080p to 1440p, and a 64% drop from 1080p to 4K. The scaling is not linear, which indicates that the GPU’s memory bandwidth and compute capacity are being saturated as resolution increases. At Medium settings, the numbers are 105 FPS at 1080p, 69 FPS at 1440p, and 38 FPS at 4K. The drop from 1080p to 1440p is 34%, and from 1080p to 4K is 64%, similar to Low settings. At High settings, the combo hits 81 FPS at 1080p, 53 FPS at 1440p, and 30 FPS at 4K, with a 35% drop from 1080p to 1440p and a 63% drop to 4K.

These consistent percentage drops across settings are a hallmark of a GPU bottleneck. The CPU, which has 8 cores and 16 threads with a boost clock of 4.80 GHz, is capable of feeding the GPU at 1080p, but at 4K, the GPU’s pixel throughput becomes the limiting factor. The B570’s pixel rate of 200.0 GPixel/s and texture rate of 360.0 GTexel/s are simply not enough to maintain high frame rates at 3840x2160. The measured minimum FPS at Medium settings illustrates this further: at 1080p Medium, the minimum is 89 FPS, but at 1440p Medium, it drops to 59 FPS, and at 4K Medium, the average is 38 FPS with no minimum reported, suggesting instability.

The 4K Ultra result of 22 FPS is the clearest evidence of the GPU’s limits. Even the CPU’s strong single-thread performance—evidenced by a Cinebench R23 single-core score of 3359 and a 3DMark single-thread score of 959—cannot compensate for the GPU’s inability to process the frame data at that resolution. The data shows that the combo is best suited for 1080p and 1440p gaming, where the GPU can keep up with the CPU’s output. At 4K, users would need to drop to Low settings just to approach 47 FPS, which is still below the 60 FPS target for most players.

Settings Recommendations

Based on the measured FPS data, the optimal settings for this combo depend on the target resolution and frame rate. At 1080p, the Medium preset delivers an average of 105 FPS with a minimum of 89 FPS, which is a smooth experience for most survival games. The High preset at 1080p drops to 81 FPS average, which is still playable, but the 24 FPS gap between Medium and High suggests that the extra visual fidelity comes at a noticeable cost. The Low preset at 1080p achieves 130 FPS, but that is likely unnecessary for a game like Palworld, where 60-100 FPS is sufficient. The Ultra preset at 1080p yields 61 FPS average, which is right at the edge of playability, but the lack of reported minimum FPS data means stability is uncertain.

At 1440p, the Medium preset is the best choice, with an average of 69 FPS and a minimum of 59 FPS. That is just above the 60 FPS target, and the minimum frame rate indicates that dips are rare. The High preset at 1440p averages 53 FPS, which is below the ideal threshold, and the Low preset at 85 FPS is playable but sacrifices visual quality. The Ultra preset at 1440p averages 40 FPS, which is too low for a smooth experience. For 4K gaming, the data is grim: the best result is 47 FPS at Low settings, and the Medium preset averages 38 FPS. Neither is ideal, but if 4K is a requirement, Low settings are the only viable option.

The recommendation is to prioritize Medium settings at 1080p or 1440p. The Medium preset at 1080p offers the best balance of visual quality and performance, with a 105 FPS average and an 89 FPS minimum. At 1440p, Medium is still acceptable, with 69 FPS average and 59 FPS minimum. Users who prefer higher visual fidelity can try High at 1080p, but the 81 FPS average is a significant drop from Medium. The Ultra preset is not recommended at any resolution above 1080p, as the 61 FPS at 1080p is the only Ultra result that approaches playability, and the 22 FPS at 4K is unusable. The data suggests that Palworld’s graphical settings have a steep performance curve, and the B570’s mid-range architecture is best matched with Medium presets.

Measured FPS Breakdown

At 1920x1080, the combo’s performance is strong across most settings. Low settings produce an average of 130 FPS, which is the highest measured result in the entire dataset. Medium settings drop to 105 FPS average, with a minimum of 89 FPS and a maximum of 121 FPS, indicating a stable frame time distribution. High settings average 81 FPS, and Ultra settings average 61 FPS. The spread from Low to Ultra is 69 FPS, which shows that Palworld’s settings have a substantial impact on performance at 1080p. The 61 FPS at Ultra is technically playable, but it is close to the threshold where dips become noticeable.

At 2560x1440, the performance drops are consistent. Low settings average 85 FPS, Medium averages 69 FPS with a minimum of 59 FPS and a maximum of 80 FPS, High averages 53 FPS, and Ultra averages 40 FPS. The Medium preset at 1440p is the only one that maintains a minimum above 60 FPS, and even that is marginal at 59 FPS. The High and Ultra presets at 1440p are below the ideal range for a survival game, where quick reactions are necessary. The Low preset at 85 FPS is playable, but the visual downgrade is significant.

At 3840x2160, the combo struggles. Low settings average 47 FPS, Medium averages 38 FPS with a minimum of 33 FPS and a maximum of 44 FPS, High averages 30 FPS, and Ultra averages 22 FPS. None of these results are ideal for a game that requires constant input and awareness. The 47 FPS at Low is the only 4K result that approaches playability, but even that is below the 60 FPS standard. The Medium preset’s minimum of 33 FPS suggests that frame pacing is inconsistent at 4K, which could lead to stuttering during intense moments. The Ultra result of 22 FPS is effectively a slideshow, and the High result of 30 FPS is not much better.

CPU Role

The AMD Ryzen 7 5800XT plays a supporting role in this combo, and the data shows it is more than capable for Palworld. With 8 cores and 16 threads based on Zen 3 architecture, the CPU has a base clock of 3.80 GHz and a boost clock of 4.80 GHz. Its Cinebench R23 multicore score of 23794 and single-core score of 3359 indicate strong performance for both multi-threaded and single-threaded workloads. In Palworld, which likely involves physics calculations and world simulation, the CPU’s 16 threads are beneficial, but the measured FPS data suggests that the GPU is the primary constraint.

The CPU’s nearest rivals—the AMD Ryzen 7 7840H, Ryzen 7 8845HS, and Ryzen 5 9600X—have average scores within 0.6% of the 5800XT. This means that swapping the CPU would have minimal impact on Palworld’s frame rates. The 5800XT’s 32 MB of shared L3 cache and DDR4 memory support with 51.2 GB/s bandwidth are sufficient for the game’s demands. The CPU’s 81st percentile ranking among all CPUs reinforces that it is not the bottleneck. At 1080p Low, where the GPU is less stressed, the combo achieves 130 FPS, which confirms the CPU’s ability to feed frames. At 4K Ultra, the CPU is clearly idle relative to the GPU, as the 22 FPS result is entirely due to the B570’s limitations.

The CPU’s benchmark scores in 3DMark also show strong multi-threading: a 16-thread score of 7683 and a max-thread score of 7680. These numbers indicate that the CPU can handle Palworld’s background processes without issue. The PassMark multithread score of 28053 further supports this. In practical terms, the 5800XT provides a stable foundation for the B570, ensuring that the GPU is not starved of data at lower resolutions. At higher resolutions, the CPU’s role diminishes, and the combo’s performance is dictated entirely by the GPU. For users considering this combo, the CPU is a reliable partner that will not hold back the GPU in Palworld, but it also cannot rescue the GPU at 4K Ultra settings.