Red Dead Redemption 2

Red Dead Redemption 2

AVERAGE FPS
74
good

This combination provides smooth gameplay with an average of 74 FPS, suitable for most gaming scenarios.

Average FPS: resolution vs quality settings

UltraHighMediumLow
4K Ultra HD 29 40 50 72
1440p QHD 46 64 78 106
1080p Full HD 65 88 106 141

Cell color: green is 120+ FPS, teal is 60+, amber is 30+, red is below 30.

Every measured configuration

3840x2160 Low 72
3840x2160 Medium 50
3840x2160 High 40
3840x2160 Ultra 29
2560x1440 Low 106
2560x1440 Medium 78
2560x1440 High 64
2560x1440 Ultra 46
1920x1080 Low 141
1920x1080 Medium 106
1920x1080 High 88
1920x1080 Ultra 65

Red Dead Redemption 2 with Intel Core i3-12100F + AMD Radeon RX 6800 XT, In-Depth Analysis

The Intel Core i3-12100F paired with the AMD Radeon RX 6800 XT presents a striking asymmetry in Red Dead Redemption 2: a high-end GPU constrained by an entry-level CPU. The benchmark data shows that this combo ranks 603 out of 1687 tested combinations, placing it in the 64th percentile overall. The results reveal a system where the GPU’s raw power is frequently held back by the processor’s four cores, making the measured frame rates more dependent on the CPU than the graphics card in several key scenarios.

Resolution Scaling

The frame rate scaling across resolutions is the clearest indicator of where the bottleneck lies. Moving from 1920x1080 to 2560x1440 at High settings, the average FPS drops from 88.2 to 63.8, a 27.7% reduction. The subsequent jump to 3840x2160 yields a further decline to 40.4 FPS, another 36.7% drop from the 1440p figure. This steep, consistent decline suggests that the system is transitioning from a CPU-bound state at lower resolutions to a more GPU-bound state at higher ones.

At Low settings, the bottleneck is even more pronounced. The 1080p Low result of 140.8 FPS drops to 106.4 FPS at 1440p and then to 71.5 FPS at 4K. The fact that the 4K Low score (71.5 FPS) is actually higher than the 1440p High score (63.8 FPS) confirms that the settings preset, not just resolution, heavily influences where performance is limited. The GPU is capable of far more at 4K Low, but the CPU appears to cap the frame rate ceiling at lower resolutions, preventing the RX 6800 XT from fully stretching its legs.

The most telling data point is the scaling from 1080p to 4K at Medium settings. The 106.2 FPS at 1080p falls to 78.2 FPS at 1440p, then to 50.1 FPS at 4K. This pattern indicates a balanced load shift. The GPU is clearly the limiting factor at 4K, as the rendering load increases dramatically, but the CPU is the primary constraint at 1080p, where the graphics card has ample headroom. The data suggests that at 1080p, the i3-12100F is the performance ceiling, while at 4K, the RX 6800 XT's capabilities are fully taxed.

GPU Role

The AMD Radeon RX 6800 XT is a high-end card built on the RDNA 2.0 architecture with a 7 nm process. It features 16 GB of GDDR6 memory on a 256-bit bus, delivering 512.0 GB/s of bandwidth. Its boost clock is rated at 2250 MHz, with a game clock of 2015 MHz. These specifications place it in the 87th percentile of all GPUs, and its average benchmark score of 49982 puts it a mere 0.5% ahead of the Intel Arc A550M and 2.6% ahead of the NVIDIA GeForce RTX 4070 Ti SUPER.

In Red Dead Redemption 2, the GPU’s role becomes increasingly dominant as resolution and settings increase. At 4K Ultra, the system produces just 28.7 FPS, a figure that reflects the immense load placed on the graphics card. The transition from 1440p High (63.8 FPS) to 4K High (40.4 FPS) shows the GPU struggling with the additional pixel count, a clear sign that the RX 6800 XT is the primary performance driver in this configuration at those settings. The 16 GB VRAM buffer is likely sufficient for the game’s textures, but the sheer computational demand of 4K Ultra proves too much for the card to maintain playable frame rates.

The measured FPS at 4K Low (71.5 FPS) compared to 4K Ultra (28.7 FPS) shows a 42.8 FPS spread, demonstrating how drastically the graphics settings impact the GPU load. This indicates that while the RX 6800 XT can handle the geometry and shading at low settings, the Ultra preset introduces effects that significantly tax the card’s 4608 shading units and 128 ROPs. The card’s 20.74 TFLOPS of FP32 performance is clearly insufficient for the most demanding presets at this resolution, making the GPU the definitive bottleneck at 4K Ultra.

CPU Role

The Intel Core i3-12100F is a 4-core, 8-thread processor from the Alder Lake family, with a base clock of 3.30 GHz and a boost clock of 4.30 GHz. It has a 12 MB shared L3 cache and supports DDR4 and DDR5 memory. Despite its modest core count, its benchmarks are respectable: a Cinebench R23 multicore score of 11912 and a single-core score of 1681. This places it in the 72nd percentile of all CPUs, with an average benchmark score of 13516, making it essentially neck-and-neck with the AMD Ryzen Threadripper PRO 3975WX, which scores 13534 (a -0.1% delta).

In this game, the CPU’s four cores are a significant limiting factor at lower resolutions. At 1080p Low, the system hits 140.8 FPS, which is the highest frame rate of any tested configuration. However, the fact that this is only 34.6 FPS higher than the 1440p Low result (106.4 FPS) suggests that the CPU is hitting a performance ceiling. The i3-12100F’s 4 cores and 8 threads may struggle to feed the GPU enough draw calls and physics data to push beyond this threshold.

The CPU’s influence is most evident when comparing the 1080p results across settings. At 1080p High, the system produces 88.2 FPS, while at 1080p Ultra it drops to 64.5 FPS. The delta between these two is 23.7 FPS, which is smaller than the 31.6 FPS gap seen between 1440p High and 1440p Ultra. This compression at 1080p indicates that the CPU is unable to fully utilize the GPU’s potential, as the graphics card is waiting for data from the processor. The boost clock of 4.30 GHz helps, but the lack of additional physical cores limits the system’s ability to maintain high frame rates when the game’s logic becomes more demanding.

Measured FPS Breakdown

The measured frame rates provide a complete picture of this combo’s performance. At 1920x1080, the average FPS ranges from a low of 64.5 at Ultra settings to a high of 140.8 at Low settings. The Medium preset yields 106.2 FPS, while High produces 88.2 FPS. This shows a 76.3 FPS difference between the lowest and highest quality settings, highlighting the CPU’s role in capping performance at the top end.

Moving to 2560x1440, the average FPS drops across the board. Low settings deliver 106.4 FPS, Medium achieves 78.2 FPS, High reaches 63.8 FPS, and Ultra falls to 46.2 FPS. The scaling from 1080p to 1440p at Low settings is a 34.4 FPS drop, while at Ultra it is only an 18.3 FPS drop. This pattern reinforces the idea that the CPU is the limiting factor at lower settings, as the GPU has more headroom, while at higher settings, the GPU becomes the primary constraint.

At 3840x2160, the system’s performance is heavily GPU-bound. Low settings average 71.5 FPS, Medium averages 50.1 FPS, High averages 40.4 FPS, and Ultra averages 28.7 FPS. The gap between Low and Ultra at 4K is 42.8 FPS, which is the largest absolute spread of any resolution. The fact that the 4K Low result (71.5 FPS) is higher than the 1440p Ultra result (46.2 FPS) underscores how much the GPU’s workload scales with resolution. The 4K Ultra figure of 28.7 FPS is the only result below 30 FPS, indicating that this setting is not playable for most users.

FAQ

Q: At what resolution and settings does this combo achieve the highest average frame rate?

A: The highest average frame rate is achieved at 1920x1080 with Low settings, producing 140.8 FPS.

Q: How does the CPU’s core count affect performance at 1080p?

A: The 4-core i3-12100F appears to limit frame rates at 1080p, as the difference between Low (140.8 FPS) and High (88.2 FPS) settings is just 52.6 FPS, suggesting the CPU cannot fully feed the GPU at lower resolutions.

Q: Is the GPU or CPU the main bottleneck at 4K Ultra?

A: At 3840x2160 Ultra, the system produces 28.7 FPS, which is the lowest score in the dataset. This indicates the RX 6800 XT is the primary limiting component, as the rendering load at this setting overwhelms the GPU.

Q: What is the performance difference between 1080p and 4K at Medium settings?

A: At Medium settings, the average FPS drops from 106.2 at 1080p to 50.1 at 4K, a 56.1 FPS reduction. This shows a significant GPU load increase with resolution.

Q: How does this combo’s GPU compare to its nearest rival in average benchmark score?

A: The RX 6800 XT’s average benchmark score is 49982, which is 0.5% higher than the Intel Arc A550M’s score of 49737.

Q: What is the lowest average FPS recorded for this combination?

A: The lowest average FPS is 28.7, recorded at 3840x2160 resolution with Ultra settings.

Hardware Specifications

Intel Core i3-12100F

Cores / Threads 4 / 8
Base Clock 3300 MHz
Boost Clock 4300 MHz
TDP 58W
Socket Intel Socket 1700
View Full CPU Details →

AMD Radeon RX 6800 XT

VRAM 16 GB GDDR6
Base Clock —
Boost Clock 2250 MHz MHz
TDP 300 WW
View Full GPU Details →

FPS Benchmarks by Resolution & Settings

Performance data for Intel Core i3-12100F + AMD Radeon RX 6800 XT in Red Dead Redemption 2

Resolution Settings Avg FPS
3840x2160 Low 71.5
3840x2160 Medium 50.1
3840x2160 High 40.4
3840x2160 Ultra 28.7
2560x1440 Low 106.4
2560x1440 Medium 78.2
2560x1440 High 63.8
2560x1440 Ultra 46.2
1920x1080 Low 140.8
1920x1080 Medium 106.2
1920x1080 High 88.2
1920x1080 Ultra 64.5

Red Dead Redemption 2 with ii3-12100F + Other GPUs

See how Red Dead Redemption 2 performs with the same CPU but different graphics cards.

Red Dead Redemption 2 with RX 6800 XT + Other CPUs

See how Red Dead Redemption 2 performs with the same GPU but different processors.

Other Games with ii3-12100F + RX 6800 XT

Explore FPS benchmarks for other games using this same hardware combination.