Downfall

The AMD Ryzen 5 7500F paired with the NVIDIA GeForce RTX 3070 Ti presents a balanced 1080p and 1440p configuration for Downfall, though the data reveals a sharp performance cliff at 4K Ultra settings. This analysis breaks down the measured frame rates, the role each component plays, and how this specific combination stacks up against the broader test pool.

Resolution Scaling

The frame rate drop from 1080p to 4K is dramatic and reveals where the bottleneck shifts. At Low settings, the transition from 1920x1080 (272.6 FPS) to 2560x1440 (195.4 FPS) represents a 28.3% reduction, and then to 3840x2160 (117.4 FPS) another 39.9% drop. This steep scaling curve indicates the GPU is increasingly the limiting factor as pixel count rises, which is expected given the 8 GB memory buffer and the bandwidth demands of 4K.

At High settings, the scaling is less severe in percentage terms but still substantial: 180.7 FPS at 1080p falls to 130.8 FPS at 1440p (a 27.6% reduction) and then to 81.9 FPS at 4K (a 37.4% further drop). The pattern here is consistent—each resolution step costs roughly a third of the remaining performance. However, the most telling data point is the Ultra preset, where 4K performance collapses to 48.8 FPS, just 43.8% of the 111.4 FPS achieved at 1080p Ultra. That is a catastrophic scaling loss.

What does this say about the limiting component? At 1080p Low, the 272.6 FPS result is so high that the CPU’s single-thread performance (3dmark_single_thread score of 974, Cinebench R23 single-core of 3218) likely begins to cap the frame rate. As resolution increases, the GPU’s raw throughput (21.75 TFLOPS FP32) and memory bandwidth (608.3 GB/s) take over as the primary constraint. The 4K Ultra result of 48.8 FPS is the clearest evidence that the RTX 3070 Ti is fully saturated at that configuration, while the CPU still has headroom.

GPU Role

The RTX 3070 Ti is built on the Ampere architecture with 6144 shading units, 192 TMUs, and 96 ROPs. Its boost clock of 1770 MHz and 8 GB of GDDR6X memory on a 256-bit bus deliver 608.3 GB/s of bandwidth. These specifications directly explain the measured results. The memory bandwidth is the critical factor for Downfall’s 4K performance; the 48.8 FPS Ultra result suggests the 8 GB frame buffer and bandwidth are insufficient for the game’s highest settings at that resolution.

The GPU’s benchmark percentile of 74 versus all GPUs indicates it sits above average, but its nearest rivals in the synthetic benchmarks are telling. The AMD Radeon RX 6700 scores 31112 (0.8% higher), the NVIDIA Quadro M5000 scores 31142 (0.9% higher), and the NVIDIA GRID M60-1Q scores 31220 (1.2% higher). These deltas are small, meaning the 3070 Ti is closely matched to those parts in general compute, but the game-specific results show where its strengths and weaknesses lie.

At 1440p Medium, the 160.1 FPS result shows the GPU handling moderate settings well. The jump from Medium to High at 1440p costs 29.3 FPS (160.1 to 130.8), and from High to Ultra costs another 49.2 FPS (130.8 to 81.6). This Ultra penalty is severe, highlighting that the 3070 Ti’s 8 GB VRAM is likely spilling over at 1440p Ultra in Downfall. The 4K data reinforces this: Medium (96.4 FPS) to High (81.9 FPS) is a 14.5 FPS drop, but High to Ultra (48.8 FPS) is a 33.1 FPS collapse.

CPU Role

The Ryzen 5 7500F is a 6-core, 12-thread Zen 4 part with a base clock of 3.70 GHz and a boost of 5.00 GHz. Its 32 MB shared L3 cache and dual-channel DDR5 memory support (83.2 GB/s bandwidth) provide solid fundamentals. The CPU’s percentile rank of 82 versus all CPUs places it well above average, and its Cinebench R23 multi-core score of 22799 and single-core of 3218 confirm strong all-around performance.

In the context of Downfall, the CPU’s role is most evident at lower resolutions. At 1080p Low, the 272.6 FPS average suggests the frame rate is approaching what the CPU can feed. The 3dmark_2_threads score of 1902 and single-thread score of 974 indicate the CPU has ample single-core power, but the game’s engine may not scale perfectly across all 12 threads. The passmark_multithread score of 26825 shows good multi-threaded capability, yet the frame rate ceiling at 1080p Low is likely a combination of CPU draw-call limits and GPU capability.

The nearest CPU rivals show how tight the competition is. The Intel Core i7-11850H scores 24974 (0.1% higher), while the AMD Ryzen 7 2700X scores 25057 (0.3% higher) and the Ryzen 5 8400F scores 25064 (0.3% higher). In synthetic benchmarks, the 7500F is essentially tied with these parts, but its 5.00 GHz boost clock gives it an edge in lightly-threaded scenarios, which is why 1080p results remain so high.

Measured FPS Breakdown

The complete measured data provides a clear picture of the combo’s behavior across twelve configurations. At 1920x1080, the results are: Low 272.6 FPS, Medium 219.3 FPS, High 180.7 FPS, and Ultra 111.4 FPS. The gap between High and Ultra at 1080p is 69.3 FPS, the largest single-setting jump at any resolution, indicating that Ultra introduces effects that heavily tax the GPU.

At 2560x1440, the scores are: Low 195.4 FPS, Medium 160.1 FPS, High 130.8 FPS, and Ultra 81.6 FPS. The Medium to High drop of 29.3 FPS is proportionally similar to 1080p, but the High to Ultra drop of 49.2 FPS is slightly less severe in percentage terms (37.6% versus 38.3% at 1080p). This suggests the GPU is becoming the limit, but the settings overhead scales similarly.

At 3840x2160, the results are: Low 117.4 FPS, Medium 96.4 FPS, High 81.9 FPS, and Ultra 48.8 FPS. The Low to Medium drop is 21 FPS, Medium to High is 14.5 FPS, and High to Ultra is a massive 33.1 FPS. The Ultra setting at 4K is the only configuration below 60 FPS, and the 48.8 FPS result is less than half of the 4K Low score. This is the clearest indicator that the 8 GB VRAM and the GPU’s compute resources are insufficient for the game’s highest preset at 4K.

How This Combo Ranks

In the database of tested combinations for Downfall, this pairing ranks 681 out of 1741 combos, placing it in the 61st percentile of all tested systems. This rank is respectable but not top-tier, reflecting the GPU’s limitations at higher resolutions. The CPU’s strong 82nd percentile ranking does not fully compensate for the GPU’s 74th percentile in the most demanding scenarios.

The rank of 681 suggests that while this combo excels at 1080p and handles 1440p well, it falls behind other pairings at 4K Ultra. The data shows the CPU is not the primary limitation—even at 4K Low (117.4 FPS), the frame rate is high enough to indicate CPU headroom. The bottleneck is squarely the GPU, particularly at Ultra settings where the 48.8 FPS 4K result drags the overall ranking down. For a user targeting 1080p or 1440p, this rank undersells the experience; for 4K enthusiasts, it accurately reflects the hardware’s ceiling.

FAQ

Q: What is the best resolution for this combo in Downfall?

A: The data shows 2560x1440 as the sweet spot. At High settings, the combo delivers 130.8 FPS, which is smooth and well above the 1080p High result of 180.7 FPS in terms of visual quality per frame. The 4K High result of 81.9 FPS is playable but leaves little headroom, and 4K Ultra drops to 48.8 FPS.

Q: How does the 8 GB VRAM affect 4K performance?

A: The 8 GB frame buffer is the likely cause of the severe Ultra preset collapse. At 4K Ultra, the average FPS is 48.8, which is 33.1 FPS lower than 4K High (81.9 FPS). This steep drop from High to Ultra suggests the VRAM capacity is exceeded, forcing texture streaming or lower-quality assets.

Q: Is the CPU holding back the GPU at 1080p?

A: At 1080p Low, the 272.6 FPS result is near the practical ceiling for many game engines, and the CPU’s single-thread score of 974 in 3dmark suggests it is the limiting factor at that extreme. However, at 1080p Ultra (111.4 FPS), the GPU is clearly the bottleneck, as the CPU has ample headroom.

Q: What settings should a 4K user choose?

A: The 4K Low setting yields 117.4 FPS, which is excellent for competitive play, while 4K Medium (96.4 FPS) and 4K High (81.9 FPS) both remain above 60 FPS. Avoid 4K Ultra, as the 48.8 FPS result is below the 60 FPS threshold.

Q: How does this combo compare to the nearest rival pairings?

A: The GPU’s nearest rival, the AMD Radeon RX 6700, scores 0.8% higher in synthetic benchmarks, while the CPU’s nearest rival, the Intel Core i7-11850H, scores 0.1% higher. These tiny deltas mean the in-game results are primarily determined by the specific game’s optimization, not the raw benchmark scores.

Q: Is the 3070 Ti’s 74th percentile ranking a concern?

A: The 74th percentile versus all GPUs indicates it outperforms about three-quarters of tested graphics cards. In Downfall, this translates to strong 1080p and 1440p performance, but the 4K Ultra result of 48.8 FPS shows it is not a 4K Ultra-class card for this title.