AMD Phenom II X6 1075T vs Intel Core i7-975 Comparison

AMD
AMD

AMD Phenom II X6 1075T

CORE STATE Thuban
CORE SPECS 6 Cores / 6 Threads
CLOCK SPEED 3 Base / 3.5 GHz Turbo
CACHE 6 MB (shared)
MAX TDP 125W
ARCHITECTURE K10
nm
PROCESS 45 nm
LAUNCH DATE 2010
VS
Intel
INTEL

Core i7-975

CORE STATE Bloomfield
CORE SPECS 4 Cores / 8 Threads
CLOCK SPEED 3.33 Base / 3.6 GHz Turbo
CACHE 8 MB (shared)
MAX TDP 130W
ARCHITECTURE Nehalem
nm
PROCESS 45 nm
LAUNCH DATE 2009

PERFORMANCE BENCHMARKS

cinebench_cinebench_r15_multicore
299
299
cinebench_cinebench_r20_multicore
1,249
1,249
cinebench_cinebench_r20_singlecore
176
175
cinebench_cinebench_r23_multicore
2,975
2,974
cinebench_cinebench_r23_singlecore
420
419

Analysis: AMD Phenom II X6 1075T vs Intel Core i7-975

The AMD Phenom II X6 1075T and the Intel Core i7-975 end up as statistical twins in the benchmark data, with the AMD part holding a razor-thin edge in every single head-to-head test. The average benchmark scores are nearly identical—1024 for the Phenom versus 1023 for the Core i7—and both processors sit at the 28th percentile of all CPUs. However, the path each chip takes to reach that parity is entirely different: the AMD uses six physical cores with no multithreading, while the Intel uses four cores with eight threads. The result is a tie in raw performance but a substantial divergence in architecture, features, and platform positioning.

Head-to-Head Benchmarks

The benchmark results are remarkably close, with the AMD Phenom II X6 1075T winning all five recorded head-to-head tests, though by margins that range from negligible to barely measurable. In Cinebench R15 multicore, both chips score exactly 299 points, a dead heat. The Cinebench R20 multicore test repeats that pattern with identical scores of 1249 for both processors. The Cinebench R23 multicore result is essentially the same story—the AMD scores 2975 against the Intel's 2974, a delta of 0%.

The single-core results are where the AMD chip ekes out its narrow victories. In Cinebench R20 single-core, the Phenom II X6 1075T scores 176 against the Core i7-975's 175, a 0.6% advantage. The Cinebench R23 single-core test shows the AMD leading 420 to 419, a 0.2% margin. While these deltas are tiny, they do give the AMD part a clean sweep of the head-to-head record at 5 wins and 0 losses.

The overall average benchmark scores confirm this near-parity: the Phenom II X6 1075T averages 1024 points, while the Core i7-975 averages 1023 points, a 0.1% difference. In the nearest rivals list, the two chips are mirror images of each other. The AMD's closest competitor is the AMD Ryzen 5 PRO 2500U at a delta of 0%, followed by the Intel Core i7-975 at 0.1%. The Intel's list shows the same relationship in reverse, with the Phenom II X6 1075T at -0.1% delta. The data suggests these two processors are effectively interchangeable in raw compute performance, despite their different designs.

Architecture Differences

The architectural gap between these two chips is substantial, even though their performance lands in the same place. The AMD Phenom II X6 1075T is built on the K10 architecture with the Thuban codename, using a 45 nm process node from GlobalFoundries. It packs 904 million transistors onto a 346 mm² die. The Intel Core i7-975 uses the Nehalem architecture with the Bloomfield codename, also on a 45 nm process node but fabricated by Intel. It contains 731 million transistors on a smaller 263 mm² die.

Core and thread counts diverge sharply. The AMD offers six physical cores and six threads, meaning no hyperthreading-style overlap. The Intel offers four physical cores and eight threads, relying on simultaneous multithreading to reach its thread count. The cache layouts reflect these different philosophies. The Phenom II X6 1075T has 128 KB of L1 cache per core and 512 KB of L2 cache per core, with 6 MB of shared L3 cache. The Core i7-975 has 64 KB of L1 per core and 256 KB of L2 per core, but a larger 8 MB of shared L3 cache.

Memory support and bandwidth also differ. The AMD processor supports both DDR2 and DDR3 memory through a dual-channel memory bus, delivering 21.3 GB/s of memory bandwidth. The Intel part is limited to DDR3 but uses a triple-channel memory bus, pushing bandwidth to 25.6 GB/s. The AMD supports ECC memory, while the Intel does not. Both use PCIe Gen 2, and neither has integrated graphics—the AMD lists "on certain motherboards (chipset feature)" while the Intel has no integrated graphics entry at all.

Where Each One Wins

Benchmark data shows the AMD Phenom II X6 1075T winning every test category, but the margins are so small that the practical distinction comes down to platform traits rather than frame rates or render times. The AMD's six physical cores give it a structural advantage in workloads that scale linearly with core count and do not benefit from multithreading tricks. The Intel's eight threads, achieved through four cores with hyperthreading, allow it to match that performance in threaded applications, as evidenced by the identical Cinebench R15 and R20 multicore scores.

The AMD wins the single-core tests by 0.6% and 0.2% in Cinebench R20 and R23, respectively. This suggests a slight edge in lightly threaded tasks, though the difference is within run-to-run variance. The Intel's triple-channel memory interface and higher memory bandwidth of 25.6 GB/s versus 21.3 GB/s for the AMD could favor memory-intensive workloads, though no benchmark in the data directly measures this. The AMD's ECC memory support makes it the more defensible choice for error-sensitive computing, while the Intel's unlocked multiplier (the AMD is locked) gives it an overclocking lever that the AMD lacks.

For users who prioritize raw core count without reliance on multithreading, the AMD's six-core design is the more straightforward option. For those who value memory bandwidth and overclocking headroom, the Intel's triple-channel setup and unlocked multiplier are the distinguishing features. The data does not show either chip pulling away in any benchmark, so the decision rests on these secondary characteristics.

Specification Differences

The two processors differ across nearly every major specification category. The AMD Phenom II X6 1075T has 6 cores and 6 threads, while the Intel Core i7-975 has 4 cores and 8 threads. Base clocks differ: the AMD runs at 3.00 GHz base and 3.50 GHz boost, while the Intel runs at 3.33 GHz base and 3.60 GHz boost. TDP ratings are close but not identical—125 watts for the AMD versus 130 watts for the Intel.

The AMD uses the AMD Socket AM3, while the Intel uses Intel Socket 1366. The AMD's architecture is K10 with codename Thuban, while the Intel uses Nehalem with codename Bloomfield. The AMD's generation is listed as "Phenom II X6 (Thuban)" and the Intel's as "Core i7 Extreme (Bloomfield)." Both use 45 nm process nodes, but the AMD is fabricated by GlobalFoundries and the Intel by Intel. Transistor counts are 904 million for the AMD versus 731 million for the Intel, and die sizes are 346 mm² versus 263 mm².

Cache configurations differ: the AMD has 128 KB L1 per core and 512 KB L2 per core, with 6 MB shared L3; the Intel has 64 KB L1 per core and 256 KB L2 per core, with 8 MB shared L3. Memory support shows the AMD accepting DDR2 and DDR3 on a dual-channel bus at 21.3 GB/s, while the Intel accepts only DDR3 on a triple-channel bus at 25.6 GB/s. ECC memory is supported on the AMD only. The AMD's multiplier is locked; the Intel's is unlocked. The Intel has a launch MSRP of $1059, while the AMD has no listed launch MSRP. Release dates differ as well: the AMD came out on 2010-09-20, the Intel on 2009-06-01.

FAQ

Q: Which processor has more cores?

A: The AMD Phenom II X6 1075T has 6 cores and 6 threads. The Intel Core i7-975 has 4 cores and 8 threads.

Q: What are the average benchmark scores for these two CPUs?

A: The AMD Phenom II X6 1075T has an average benchmark score of 1024, while the Intel Core i7-975 has an average score of 1023. They sit at the 28th percentile of all CPUs.

Q: Which chip wins in single-core performance?

A: The AMD Phenom II X6 1075T wins in both single-core tests, scoring 176 versus 175 in Cinebench R20 single-core (0.6% delta) and 420 versus 419 in Cinebench R23 single-core (0.2% delta).

Q: Do the two processors support the same memory types?

A: No. The AMD supports both DDR2 and DDR3 on a dual-channel bus with 21.3 GB/s bandwidth and ECC memory. The Intel supports only DDR3 on a triple-channel bus with 25.6 GB/s bandwidth and no ECC support.

Q: Is either processor overclockable?

A: The Intel Core i7-975 has an unlocked multiplier, making it overclockable. The AMD Phenom II X6 1075T has a locked multiplier.

Q: What is the TDP of each processor?

A: The AMD Phenom II X6 1075T has a TDP of 125 watts. The Intel Core i7-975 has a TDP of 130 watts.

The Verdict

The benchmark data shows these two processors are performance equals, with the AMD Phenom II X6 1075T holding a 5-0 head-to-head record but by margins of 0% to 0.6%. The average scores of 1024 versus 1023 and identical 28th percentile rankings mean neither chip offers a meaningful raw performance advantage. The choice between them must be made on platform features and design philosophy.

The AMD Phenom II X6 1075T is the pick for users who want six physical cores without any reliance on multithreading, who need ECC memory support, or who are constrained to the AMD Socket AM3 platform. Its dual-channel memory support for both DDR2 and DDR3 offers flexibility, and its lower 125-watt TDP makes it slightly more power-efficient than the Intel part.

The Intel Core i7-975 is the pick for users who value memory bandwidth—its triple-channel DDR3 setup delivers 25.6 GB/s versus the AMD's 21.3 GB/s—or who want an unlocked multiplier for overclocking. It also comes from the Core i7 Extreme line, carries a launch MSRP of $1059, and has 8 MB of L3 cache versus the AMD's 6 MB. The Intel's larger L3 cache and higher base and boost clocks (3.33 GHz and 3.60 GHz versus 3.00 GHz and 3.50 GHz) do not translate into benchmark wins, but they remain structural differences.

In practical terms, the data says either processor will deliver the same Cinebench performance. The AMD wins on core count and ECC support; the Intel wins on memory bandwidth, overclocking freedom, and cache size. Neither chip is faster in any meaningful way, so the deciding factor is which platform features matter more to the workload at hand.

DETAILED SPECIFICATIONS

SPECIFICATION
Phenom II X6 1075T
i7-975
Core Specs
Cores
6
4 -33.3%
Threads
6
8 +33.3%
Base Clock (GHz)
3
3.33 +11.0%
Boost Clock (GHz)
3.5
3.6 +2.9%
Frequency (GHz)
3
3.33 +11.0%
Turbo Clock (GHz)
3.5
3.6 +2.9%
Multiplier
15
25 +66.7%
SMP CPUs
1
1 0.0%
Cache
L1 Cache
128 KB (per core)
64 KB (per core)
L2 Cache
512 KB (per core)
256 KB (per core)
L3 Cache
6 MB (shared)
8 MB (shared)
Power
TDP (W)
125
130 +4.0%
Architecture
Architecture
K10
Nehalem
Codename
Thuban
Bloomfield
Generation
Phenom II X6 (Thuban)
Core i7 Extreme (Bloomfield)
Process Size
45 nm
45 nm
Transistors
904 million
731 million
Die Size
346 mm²
263 mm²
Foundry
GlobalFoundries
Intel
Memory
Memory Support
DDR2, DDR3
DDR3
Memory Bus
Dual-channel
Triple-channel
Memory Bandwidth
21.3 GB/s
25.6 GB/s
ECC Memory
Yes
No
Platform
Socket
AMD Socket AM3
Intel Socket 1366
Chipsets
AMD 700 Series, AMD 800 Series, AMD 900 Series, nForce 630a, nForce 700a, nForce 900a
—
PCIe
Gen 2
Gen 2
Graphics
Integrated Graphics
On certain motherboards (Chipset feature)
—
Other
Market
Desktop
Desktop
Production Status
End-of-life
End-of-life
Launch Price
—
$1059
Part Number
HDT75TFBK6DGRHDT75TFBGRBOX
SLBEQ
Package
µPGA
FC-LGA8
Bundled Cooler
—
Yes
View Phenom II X6 1075T Details View Core i7-975 Details