Palworld

Palworld with an Intel Core i7-14700F and AMD Radeon RX 7600 presents a specific performance profile that shifts dramatically depending on resolution and settings. The data shows a pairing where the CPU provides ample headroom, but the GPU dictates the experience at higher graphical loads. This analysis breaks down the measured FPS, contextualizes the combo’s standing among other tested configurations, and explains the roles each component plays.

Resolution Scaling

The FPS drop from 1080p to 4K is steep and reveals a clear GPU bottleneck at higher resolutions. At High settings, the average frame rate falls from 95 FPS at 1920x1080 to 63 FPS at 2560x1440, a 34% reduction. Moving to 3840x2160, the average plummets to 35 FPS, which is a further 44% drop from the 1440p result. This scaling pattern indicates that the Radeon RX 7600’s rendering throughput is the limiting factor as pixel count increases.

The trend is consistent across all settings presets. At Low settings, the average FPS goes from 152 at 1080p to 100 at 1440p and then to 56 at 4K. At Medium, the numbers are 123, 81, and 45 respectively. Even at Ultra, which yields the lowest overall performance, the drop from 72 FPS at 1080p to 47 FPS at 1440p and then 26 FPS at 4K shows the same pattern. The consistent proportional decline suggests that the CPU is not the primary constraint in these scenarios.

What this means practically is that 1080p is the sweet spot for high refresh rate monitors, with the combo delivering well over 60 FPS on High and 123 FPS on Medium. At 1440p, the system remains playable for most users, but you will need to adjust settings; Medium at 81 FPS is viable, while High at 63 FPS is borderline for competitive play. At 4K, the RX 7600 is simply overwhelmed, with only the Low preset achieving a playable 56 FPS average, while High and Ultra fall below 35 FPS.

How This Combo Ranks

In the database of tested combinations, this specific pairing of the Core i7-14700F and Radeon RX 7600 ranks 2578th out of 3711 combos for Palworld. This places it in the lower third of all tested configurations, which is a direct consequence of the GPU’s mid-range positioning. The percentile data confirms this, with the GPU sitting at the 57th percentile versus all GPUs, while the CPU is far more capable at the 91st percentile versus all CPUs.

The ranking indicates that while the processor is a strong performer, the overall gaming experience in Palworld is held back by the graphics card. This is not a poorly balanced system for 1080p gaming, but the combo rank reflects its limitations at higher resolutions. The data suggests that many other combinations, particularly those with more powerful GPUs, will achieve higher frame rates in this title, making this pairing a mid-tier option rather than a high-end one.

When looking at the CPU’s nearest rivals, the Core i7-14700F’s average benchmark score of 53620 is nearly identical to the Intel Xeon 6505P (53701, delta -0.2%) and slightly higher than the AMD Ryzen 9 7900X (53288, delta 0.6%). This shows the CPU is competitive with high-end desktop processors. For the GPU, the RX 7600’s average score of 15171 is within a fraction of a percent of the NVIDIA GeForce RTX 3050 OEM (15199, delta -0.2%), indicating they are performance peers in synthetic tests. This context is important: the CPU can handle far more than the GPU can deliver.

GPU Role

The AMD Radeon RX 7600 is built on the RDNA 3.0 architecture with the Navi 33 chip. It features 8 GB of GDDR6 memory on a 128-bit bus, providing a bandwidth of 288.0 GB/s. The GPU has a base clock of 1720 MHz, a game clock of 2250 MHz, and a boost clock of 2655 MHz. These specifications point to a card designed for 1080p gaming, which aligns with the measured results.

In Palworld, the 8 GB VRAM capacity is sufficient for the tested resolutions and settings, as the game’s demands do not appear to exceed this limit in the data. The clock speeds are adequate for generating high frame rates at 1080p, as evidenced by the 152 FPS average at Low settings. However, the GPU’s raw compute power, measured at 21.75 TFLOPS FP32, is not enough to maintain high frame rates at 4K. The pixel rate of 169.9 GPixel/s and texture rate of 339.8 GTexel/s become limiting factors when the render target is large.

The GPU’s performance metrics show a clear ceiling. At 4K Ultra, the average FPS falls to 26, which is below the threshold for smooth gameplay. The card’s 64 ROPs and 128 TMUs are simply not enough to handle the pixel and texture workload at that resolution. The data supports the conclusion that the RX 7600 is best suited for 1080p and entry-level 1440p gaming, with its performance degrading significantly as resolution increases.

FAQ

Q: Can this combo run Palworld at 60 FPS on High settings?

A: Yes, at 1920x1080, the average FPS is 95 on High settings, which is well above 60. At 2560x1440, the average drops to 63 FPS, which is still technically above 60 but with less headroom. At 3840x2160, it falls to 35 FPS, so 60 FPS is not achievable at 4K.

Q: What is the best resolution for this setup?

A: The data shows 1920x1080 is the optimal resolution for this pairing. At 1080p, even the Ultra preset achieves a 72 FPS average, while Medium and High provide 123 and 95 FPS respectively, offering the best balance of visual quality and performance.

Q: How does the Intel Core i7-14700F compare to its nearest rival, the AMD Ryzen 9 7900X, in synthetic benchmarks?

A: The i7-14700F has an average benchmark score of 53620, which is 0.6% higher than the Ryzen 9 7900X’s score of 53288. The delta between them is minimal, indicating they are essentially equivalent in overall CPU performance.

Q: Is the Radeon RX 7600 a bottleneck for the Core i7-14700F in this game?

A: Yes, the benchmark results indicate a GPU bottleneck at higher resolutions. While the CPU is in the 91st percentile of all CPUs, the GPU is in the 57th percentile. The FPS scaling from 1080p to 4K drops off more sharply than what a CPU-limited scenario would show, pointing to the GPU as the limiting component.

Q: What is the minimum FPS recorded for this combo?

A: The only preset with a recorded minimum FPS is Medium. At 1920x1080, the minimum is 105 FPS; at 2560x1440, it is 69 FPS; and at 3840x2160, it is 38 FPS. No minimum FPS data is listed for Low, High, or Ultra presets.

Q: How does the RX 7600’s performance compare to the NVIDIA GeForce RTX 3050 OEM?

A: According to the passmark G3D benchmark, the RX 7600 scores 16634, while the RTX 3050 OEM is a nearest rival with an average score of 15199, a delta of -0.2%. This indicates the RX 7600 is slightly faster on average, but the two are close enough to be considered peers in performance.

Measured FPS Breakdown

The following are the exact measured average frame rates for this combo, organized by resolution and settings.

1920x1080:

• Low: 152 FPS
• Medium: 123 FPS (min 105, max 142)
• High: 95 FPS
• Ultra: 72 FPS

2560x1440:

• Low: 100 FPS
• Medium: 81 FPS (min 69, max 93)
• High: 63 FPS
• Ultra: 47 FPS

3840x2160:

• Low: 56 FPS
• Medium: 45 FPS (min 38, max 52)
• High: 35 FPS
• Ultra: 26 FPS

The pattern is clear: at every resolution, the Low preset provides the highest frame rate, and the Ultra preset provides the lowest. The Medium preset offers a middle ground with a notable jump from Low, showing that the game’s settings have a significant impact on performance. The gap between Medium and High is also consistent, typically a 15-20% reduction in FPS, which suggests that High settings add a considerable load without a proportional visual benefit for this hardware.

CPU Role

The Intel Core i7-14700F is a 20-core, 28-thread processor based on the Raptor Lake architecture. It has a base clock of 2.10 GHz and a boost clock of 5.40 GHz, with a 33 MB shared L3 cache. This is a high-end desktop CPU, as evidenced by its 91st percentile ranking against all CPUs and a strong average benchmark score of 53620. In synthetic tests, it scores 35122 in Cinebench R23 multi-core and 4958 in single-core, showing robust multi-threaded and single-threaded capabilities.

In Palworld, the CPU’s role is to feed the GPU with data and handle game logic. Given the FPS data, the i7-14700F is not the limiting factor in this combo. At 1080p Low, the system achieves 152 FPS, which is a high frame rate that still does not appear to be CPU-bound. If the CPU were the bottleneck, we would expect to see similar FPS numbers across different resolutions at the same settings, but that is not the case. The FPS drops consistently with resolution, which is the signature of a GPU limit.

The CPU’s high boost clock and large cache help ensure that frame times remain consistent, even in complex scenes with many entities. The 65W TDP for this processor is modest, but the performance data shows it has ample headroom for this game. The nearest rivals, such as the AMD Ryzen 9 7900X, have nearly identical average scores, confirming that the i7-14700F is a top-tier processor that will not hold back a mid-range GPU like the RX 7600. The data strongly suggests that any performance improvements in Palworld for this combo would require a GPU upgrade, not a CPU upgrade.