Pc Building Simulator

The AMD Ryzen 9 9900X3D paired with the AMD Radeon RX 9060 shows a clear pattern in Pc Building Simulator: the GPU is the decisive bottleneck at higher resolutions, while the CPU’s high core count and cache keep frame rates high at 1080p. The measured data spans four settings presets across three resolutions, and the results show how this combination behaves as a balanced mid-range pairing rather than a top-tier contender.

Resolution Scaling

The frame rate drop from 1920x1080 to 3840x2160 is steep and consistent across all settings. At Low settings, the average FPS falls from 247 at 1080p to 156 at 1440p, then to 82 at 4K. That is a 66.8% reduction from 1080p to 4K. At Ultra settings, the drop is less dramatic in absolute terms but proportionally similar: 118 FPS at 1080p falls to 74 FPS at 1440p and then to 39 FPS at 4K, a 66.9% reduction overall.

The pattern indicates that the RX 9060’s memory bandwidth and pixel throughput become limiting factors as resolution increases. The GPU’s 8 GB GDDR6 memory on a 128-bit bus with 288.0 GB/s bandwidth is adequate for 1080p, but the 4K results show the card struggling to maintain playable rates. At 4K High, the average is 41 FPS, and at 4K Ultra it drops to 39 FPS—both below the 60 FPS threshold that most users would consider smooth.

Comparing resolution scaling between settings reveals that the GPU is the primary constraint across the board. At 1080p, the difference between Low and Ultra is 129 FPS (247 vs 118), which shows headroom in the CPU. At 4K, the same comparison yields only 43 FPS difference (82 vs 39), indicating that the GPU is saturated and settings changes have less impact. The data suggests that for this combo, 1440p is the practical ceiling for high refresh rates, while 4K requires dropping to Low to approach 60 FPS.

FAQ

Q: What is the best resolution for this CPU-GPU combo in Pc Building Simulator?

A: Based on the measured FPS, 2560x1440 provides the best balance. At Medium settings, the combo averages 111 FPS with a minimum of 94 FPS, while at High it averages 78 FPS. Both are well above the 60 FPS threshold, and the 1440p Medium preset delivers the smoothest experience without the massive frame rate penalty seen at 4K.

Q: Can this combo handle 4K gaming in Pc Building Simulator?

A: Yes, but only at lower settings. At 4K Low, the average FPS is 82, which is playable. However, at 4K Medium the average drops to 58 FPS with a minimum of 49 FPS, and at High and Ultra it falls to 41 and 39 FPS respectively. For a consistent 60 FPS at 4K, users would need to stay at Low settings.

Q: How does the RX 9060 compare to its nearest rivals in raw GPU benchmarks?

A: The RX 9060 has an average benchmark score of 16014, placing it just 0.7% behind the NVIDIA GeForce RTX 3060 Ti (16129). It is 1% ahead of both the AMD Radeon R9 370X (15862) and the AMD Radeon RX 7700 (15852), and 2.1% ahead of the AMD Radeon Pro W5500 (15679). The GPU sits at the 59th percentile of all GPUs.

Q: What is the CPU’s benchmark standing relative to its direct competitors?

A: The Ryzen 9 9900X3D has an average benchmark score of 54762, which is 0.6% below the Intel Core Ultra 5 245KF (55093). It is 1.3% ahead of the Intel Core Ultra 5 245K (54053), 2% ahead of the Intel Xeon 6505P (53701), and 2.1% ahead of the Intel Core i7-14700F (53620). The CPU ranks at the 91st percentile of all CPUs.

Q: Does the 8 GB VRAM on the RX 9060 cause issues at higher resolutions?

A: The data shows a significant performance drop from 1440p to 4K. At Medium settings, the average FPS falls from 111 at 1440p to 58 at 4K—a 47.7% reduction. While the 8 GB memory on a 128-bit bus is not explicitly cited as the cause, the pattern is consistent with VRAM capacity or bandwidth becoming a constraint at 4K resolution.

Q: How does this combo rank among all tested configurations for this game?

A: The combo ranks 2181 out of 3723 tested combinations, placing it in the lower half (approximately 41st percentile) of all configurations. This indicates that while the individual components are mid-range performers, the pairing does not produce exceptional results specifically in Pc Building Simulator.

GPU Role

The AMD Radeon RX 9060 is built on the RDNA 4.0 architecture with the Navi 44 chip, manufactured on a 4 nm process at TSMC. It features 1792 shading units, 112 texture mapping units, and 64 render output units. The GPU operates at a base clock of 1700 MHz, a game clock of 2400 MHz, and a boost clock of 2990 MHz. Memory runs at 2250 MHz with 18 Gbps effective speed, providing 288.0 GB/s of bandwidth over a 128-bit bus.

In Pc Building Simulator, the GPU’s raw compute capabilities translate into strong 1080p performance but weaken at higher resolutions. The pixel rate of 191.4 GPixel/s and texture rate of 334.9 GTexel/s are sufficient for 1080p, where the combo achieves 247 FPS at Low settings. However, at 4K, the same settings yield only 82 FPS, suggesting that the memory subsystem cannot keep up with the increased pixel workload.

The GPU’s FP32 performance of 21.43 TFLOPS places it in a competitive position for its class, but the measured FPS data shows that this compute power is not fully utilized at 4K. The card’s average benchmark score of 16014 puts it at the 59th percentile of all GPUs, just 0.7% behind the RTX 3060 Ti. This is reflected in the 4K results, where the RX 9060 trails what a higher-tier card might achieve.

The GPU’s 8 GB VRAM is adequate for 1080p and 1440p in this simulation game, but the 4K Medium result of 58 FPS (with a minimum of 49 FPS) suggests that memory pressure is starting to affect frame pacing. The 128-bit bus width is a notable limitation, as it halves the memory bandwidth compared to wider-bus cards in the same performance tier.

How This Combo Ranks

The combination of the Ryzen 9 9900X3D and RX 9060 ranks 2181 out of 3723 tested combos in Pc Building Simulator. This places the pairing in the lower 41% of all configurations, which is consistent with the GPU’s mid-range standing (59th percentile) rather than the CPU’s high standing (91st percentile).

The ranking indicates that the GPU is the limiting factor in this game. The CPU’s strong benchmark scores—including a Cinebench R23 multi-core score of 47737 and a Geekbench multi-core score of 22884—do not translate into a high combo rank because the game’s demands are primarily GPU-bound at the tested resolutions. The combo rank being significantly lower than the CPU percentile suggests that upgrading the GPU would yield a larger performance improvement than upgrading the CPU.

When compared to other tested combos, this pairing sits in a zone where many mainstream configurations with mid-range GPUs and high-end CPUs land. The 4K results (39-82 FPS depending on settings) and 1440p results (74-156 FPS) are typical for a GPU in the RTX 3060 Ti performance class. The data does not show any unusual synergy or bottleneck between the CPU and GPU—the results are predictable given the individual component benchmarks.

Settings Recommendations

Based on the measured FPS data, the optimal settings depend on the target resolution. At 1080p, the Ultra preset averages 118 FPS, which is smooth for most displays. The Medium preset averages 175 FPS with a minimum of 149 FPS, making it the best choice for high-refresh-rate monitors (144Hz or higher). The Low preset’s 247 FPS is excessive for most users and offers diminishing returns.

At 1440p, the Medium preset delivers the best experience with an average of 111 FPS and a minimum of 94 FPS. This keeps frame times consistent and avoids the occasional dips that might occur at High settings, which average 78 FPS. The Ultra preset at 74 FPS is playable but leaves little headroom for demanding scenes. For users with 60Hz monitors, the High preset at 78 FPS is sufficient.

At 4K, the Low preset is the only option that maintains an average above 60 FPS (82 FPS). The Medium preset averages 58 FPS with a minimum of 49 FPS, which may result in visible stuttering during complex scenes. High (41 FPS) and Ultra (39 FPS) are not recommended for a smooth experience. Users prioritizing visual fidelity over frame rate could use Medium, but the data suggests Low is the most consistent choice.

The sweet spot for this combo is 1440p with Medium settings, offering 111 FPS average and a minimum of 94 FPS. This balances visual quality with performance, and the 94 FPS minimum ensures that the experience remains fluid even in the most demanding moments of the simulation.

Measured FPS Breakdown

At 1920x1080, the combo delivers its strongest results. Low settings produce an average of 247 FPS. Medium settings average 175 FPS, with a minimum of 149 FPS and a maximum of 201 FPS. High settings average 124 FPS. Ultra settings average 118 FPS. The spread from Low to Ultra is 129 FPS, showing that the CPU can feed the GPU efficiently at this resolution.

At 2560x1440, performance scales down predictably. Low settings average 156 FPS. Medium settings average 111 FPS, with a minimum of 94 FPS and a maximum of 127 FPS. High settings average 78 FPS. Ultra settings average 74 FPS. The 1440p results show a 82 FPS difference between Low and Ultra, indicating that the GPU is starting to become the primary constraint.

At 3840x2160, the GPU becomes the clear bottleneck. Low settings average 82 FPS. Medium settings average 58 FPS, with a minimum of 49 FPS and a maximum of 66 FPS. High settings average 41 FPS. Ultra settings average 39 FPS. The difference between Low and Ultra at 4K is only 43 FPS, confirming that the GPU is saturated and additional settings changes have minimal impact.

The Medium settings rows are the only ones with minimum and maximum FPS data. At 1080p Medium, the range is 149-201 FPS (52 FPS spread). At 1440p Medium, the range narrows to 94-127 FPS (33 FPS spread). At 4K Medium, the range tightens further to 49-66 FPS (17 FPS spread). This decreasing variance at higher resolutions indicates that the GPU is consistently hitting its performance ceiling, leaving less room for scene-to-scene variation.

CPU Role

The AMD Ryzen 9 9900X3D is a 12-core, 24-thread processor based on the Zen 5 architecture (Granite Ridge). It has a base clock of 4.40 GHz and a boost clock of 5.50 GHz, with a TDP of 120 W. The CPU features 128 MB of L3 cache, with 80 KB L1 and 1 MB L2 per core. It supports DDR5 memory in a dual-channel configuration with a bandwidth of 89.6 GB/s.

In Pc Building Simulator, the CPU’s strong multi-threaded performance ensures that the game logic and simulation calculations never become a bottleneck. The Cinebench R23 multi-core score of 47737 and the Passmark multi-thread score of 56154 place this processor well above the needs of most simulation games. The single-thread performance is equally robust, with a Cinebench R23 single-core score of 6739 and a Geekbench single-core score of 3041.

The 128 MB L3 cache is particularly relevant for simulation games, which often have large working sets of data that benefit from cache hits. However, the measured FPS data shows that the CPU’s capabilities are not fully utilized in this game. At 1080p Low, the combo achieves 247 FPS, but at 4K Ultra it drops to 39 FPS—a clear indication that the GPU is the limiting factor.

The CPU’s benchmark percentile of 91% versus the GPU’s 59% highlights the imbalance in this pairing. The Ryzen 9 9900X3D is a high-end processor that outperforms its nearest rivals—including the Intel Core Ultra 5 245KF, which is only 0.6% faster in average benchmark score—but this advantage does not translate into higher frame rates in Pc Building Simulator because the game is not CPU-bound at the tested settings.

The multi-threaded benchmarks, such as the 3DMark max threads score of 13795 and the Passmark floating point math score of 119622, show that the CPU has ample headroom for any background tasks or future game updates. However, for this specific game, the data suggests that users would benefit more from a stronger GPU than from the CPU’s extra cores and cache. The combo’s rank of 2181 out of 3723 confirms that the pairing is balanced toward CPU performance, which does not align perfectly with the game’s GPU-heavy demands.