Can I Run It?

Instant compatibility check with FPS benchmarks and optimization tips

Overpower
Action 2023

Overpower

52%
Playable Your system meets minimum requirements.

Performance

1080p (Full HD)

Low 1080p Measured
72 FPS
Ultra 1080p Measured
35 FPS

1440p (2K / QHD)

Low 1440p Measured
64 FPS
Ultra 1440p Measured
31 FPS

4K (Ultra HD)

Low 4K Measured
54 FPS
Ultra 4K Measured
26 FPS
23.8ms Frame Time
36ms Input Latency
1440p Best Resolution

Requirements Check

Processor
Required 37,513
Your CPU 37,943
Graphics Card
Required 27,382
Your GPU 1,482

Recommendations

Upgrade Needed

Your hardware doesn't meet minimum requirements for this game.

Average FPS: resolution vs quality settings

UltraHighMediumLow
4K Ultra HD 26 32 34 54
1440p QHD 31 37 40 64
1080p Full HD 35 42 45 72

Cell color: green is 120+ FPS, teal is 60+, amber is 30+, red is below 30. Cards marked Estimated above have no measured row and are scaled from your GPU benchmark percentile.

Every measured configuration

1920x1080 High 42
1920x1080 Low 72
1920x1080 Medium 45
1920x1080 Ultra 35
2560x1440 High 37
2560x1440 Low 64
2560x1440 Medium 40
2560x1440 Ultra 31
3840x2160 High 32
3840x2160 Low 54
3840x2160 Medium 34
3840x2160 Ultra 26

Performance Analysis: Overpower on Your System

The AMD Ryzen 7 9700X paired with the Intel Arc B390 presents a specific performance profile in Overpower, a game released in August 2023. The recorded data shows this combination operating within a narrow frame rate band across all tested resolutions, with the playable threshold set at 60 frames per second. The benchmark results reveal that only the lowest graphical preset achieves that target, and only at 2560x1440 and 1920x1080. At 4K, no setting reaches the playable mark. This analysis breaks down the measured frames per second, the division of labor between the CPU and GPU, comparable hardware alternatives, and the practical verdict for each resolution.

Measured FPS Breakdown

The database contains measured average frame rates for four settings (Low, Medium, High, Ultra) at three resolutions. For 3840x2160, the Low preset delivers an average of 54 FPS. Medium drops to 34 FPS average, with a recorded minimum of 29 FPS and a maximum of 39 FPS. High averages 32 FPS. Ultra averages 26 FPS. No minimum or maximum values are listed for Low, High, or Ultra at this resolution, so only the Medium preset provides a full range of observed frames.

At 2560x1440, the Low preset averages 64 FPS. Medium averages 40 FPS, with a minimum of 34 FPS and a maximum of 46 FPS. High averages 37 FPS. Ultra averages 31 FPS. Again, only Medium includes min and max values in the recorded data. The step from Low to Medium represents a 24 FPS drop, which is the largest single-setting penalty at this resolution.

At 1920x1080, the Low preset averages 72 FPS. Medium averages 45 FPS, with a minimum of 38 FPS and a maximum of 52 FPS. High averages 42 FPS. Ultra averages 35 FPS. The gap between Low and Medium is 27 FPS, slightly larger than the 1440p gap. The difference between High and Ultra is 7 FPS, which is the smallest preset-to-preset delta across all resolutions.

Comparing resolutions at the same setting, Low preset shows 72 FPS at 1080p, 64 FPS at 1440p, and 54 FPS at 4K. That is a drop of 8 FPS from 1080p to 1440p, and another 10 FPS from 1440p to 4K. Medium preset shows 45 FPS at 1080p, 40 FPS at 1440p, and 34 FPS at 4K. High preset shows 42 FPS at 1080p, 37 FPS at 1440p, and 32 FPS at 4K. Ultra preset shows 35 FPS at 1080p, 31 FPS at 1440p, and 26 FPS at 4K. The consistent pattern is a drop of roughly 5 to 8 FPS for each step up in resolution, regardless of the preset.

The min and max data for Medium settings reveal a tight variance. At 4K, the range is 29 to 39 FPS, a span of 10 FPS. At 1440p, the range is 34 to 46 FPS, also a span of 12 FPS. At 1080p, the range is 38 to 52 FPS, a span of 14 FPS. The frame time consistency appears slightly better at lower resolutions, but the sample size is limited to only one setting per resolution.

CPU and GPU Roles

The AMD Ryzen 7 9700X is a desktop processor with 8 cores and 16 threads, based on the Zen 5 architecture. Its benchmark scores show strong multicore performance, with a Cinebench R23 multicore score of 20485 and a Geekbench multicore score of 17906. The single-thread scores are also notable, including a Geekbench single-core score of 3023 and a Passmark single-thread score of 4654. This CPU sits at the 86th percentile among all tested CPUs, suggesting it has ample headroom for most gaming workloads.

The Intel Arc B390 is an integrated graphics solution based on the Xe3-LPG architecture. Its only recorded benchmark is a 3DMark Steel Nomad DX12 score of 1482, which places it at the 9th percentile among all GPUs. That is a very low standing. The GPU has 1536 shading units, 48 texture mapping units, and 24 raster output units. Its peak pixel rate is 60.00 gigapixels per second, and its texture rate is 120.0 gigatexels per second. The FP32 performance is 7.680 TFLOPS.

Given the CPU's high percentile ranking and the GPU's very low percentile ranking, the data strongly suggests the GPU is the limiting factor in this combination. The measured FPS scaling supports this interpretation. When moving from 1080p to 1440p, the average FPS drops by about 11 to 12 percent across all presets. When moving from 1440p to 4K, the drop is roughly 16 to 19 percent. These resolution penalties are typical of GPU-bound scenarios, where increasing pixel count directly reduces frame rate.

If the CPU were the bottleneck, the frame rates would stay relatively flat across resolutions. That is not the case here. The CPU's single-thread and multithread scores are far above what this GPU can utilize in most gaming situations. The integrated graphics solution draws from system memory, and its memory bandwidth is listed as system dependent, which introduces additional variability. The CPU's memory bandwidth is rated at 89.6 GB/s, but the GPU's effective bandwidth depends on the system configuration, which is not specified in the database.

The preset scaling also points to GPU limitation. The jump from Low to Medium costs 20 FPS at 1080p (72 to 45), 24 FPS at 1440p (64 to 40), and 20 FPS at 4K (54 to 34). These are large penalties for a single step in quality. The step from High to Ultra costs 7 FPS at 1080p, 6 FPS at 1440p, and 6 FPS at 4K, which is smaller but still consistent. The GPU's low raw throughput, as indicated by its 7.680 TFLOPS FP32 rate, explains why even modest quality increases cause significant frame rate reductions.

Similar Performance Alternatives

The CPU's nearest rivals in the database are all within a 0.4 percent average score difference. The Intel Core i9-14901E has an average score of 37911, which is 0.1 percent higher than the Ryzen 7 9700X's 37943 average. The AMD Ryzen AI 9 HX 370 scores 37904, also 0.1 percent lower. The Intel Core 5 211E scores 37829, a 0.3 percent difference. The AMD Ryzen AI Embedded P132 scores 37804, a 0.4 percent difference. None of these CPUs would change the gaming outcome in Overpower, because the GPU is the binding constraint. Swapping the CPU for any of these alternatives would produce nearly identical measured frame rates.

The GPU's nearest rivals are significantly older and weaker parts. The NVIDIA GeForce GT 520MX scores 1463, which is 1.3 percent lower than the Arc B390's 1482. The NVIDIA GeForce 800M scores 1460, a 1.5 percent difference. The NVIDIA GeForce GT 625 OEM scores 1446, a 2.5 percent difference. The NVIDIA GeForce GT 710 scores 1443, a 2.7 percent difference. These are all integrated or entry-level discrete GPUs from a much older era. The Arc B390 is only slightly faster than these parts, which reinforces its low standing at the 9th GPU percentile.

For a user seeking similar behavior in Overpower, any of these rival GPUs would produce frame rates within a few percentage points of the measured values. The differences are small enough that the playable status at each resolution would remain the same. Only the Low preset at 1440p and 1080p would cross the 60 FPS threshold, and even then, the margin is narrow (64 FPS and 72 FPS respectively). A rival GPU with a 2.7 percent lower score would still average roughly 62 FPS at 1080p Low, so the verdict would not change.

FAQ

Q: Can this PC run Overpower at 60 FPS on High settings?

A: No. The measured average FPS on High settings is 42 at 1920x1080, 37 at 2560x1440, and 32 at 3840x2160. None of these reach the 60 FPS playable threshold.

Q: What is the best playable setting at 2560x1440?

A: The Low preset is the only setting that averages above 60 FPS at this resolution, with a measured average of 64 FPS. Medium averages 40 FPS, which is below the threshold.

Q: Does the 4K resolution offer any playable options?

A: No. The highest average FPS at 3840x2160 is 54 on Low settings. Medium averages 34 FPS, High averages 32 FPS, and Ultra averages 26 FPS. No setting reaches 60 FPS.

Q: Which component is more responsible for the frame rates in Overpower?

A: The Intel Arc B390 GPU is the limiting factor. Its 3DMark Steel Nomad score of 1482 places it at the 9th percentile among GPUs, while the Ryzen 7 9700X sits at the 86th percentile among CPUs. The large FPS drops when increasing resolution or quality settings are consistent with GPU-bound performance.

Q: How does the frame rate change from 1080p to 1440p on Low settings?

A: The average FPS drops from 72 at 1920x1080 to 64 at 2560x1440, a decrease of 8 FPS. The game remains playable at both resolutions on Low settings, but the margin above 60 FPS shrinks.

Q: Are there any settings with recorded minimum FPS data?

A: The database includes minimum and maximum FPS only for the Medium preset at each resolution. At 1080p, the range is 38 to 52 FPS. At 1440p, it is 34 to 46 FPS. At 4K, it is 29 to 39 FPS. No min or max values are provided for Low, High, or Ultra.

How This Combo Ranks

The combination of the AMD Ryzen 7 9700X and the Intel Arc B390 ranks 3301 out of 3713 tested combos in Overpower. That places it in the bottom 11 percent of all tested systems. The rank is driven almost entirely by the GPU, given the CPU's high standing at the 86th percentile. The data shows that even a very capable processor cannot compensate for a graphics solution that sits at the 9th percentile.

In practical terms, this rank means the system is far behind the majority of tested configurations. Most other combos in the database likely achieve playable frame rates at higher settings or resolutions. This combo only manages to cross the 60 FPS threshold on the lowest settings at 1440p and 1080p. The rank reflects that limited capability. Users with this hardware should expect to make significant quality concessions to stay above 60 FPS.

The gap between the CPU's rank and the GPU's rank is stark. A CPU in the 86th percentile paired with a GPU in the 9th percentile creates a heavily unbalanced system for gaming. The recorded FPS data confirms that the GPU dictates the outcome. Upgrading the GPU would improve the rank substantially, while upgrading the CPU would yield no measurable benefit for Overpower.

Best Settings per Resolution

At 3840x2160, no setting reaches the 60 FPS threshold. The best average FPS is 54 on Low settings. Medium averages 34 FPS, High averages 32 FPS, and Ultra averages 26 FPS. Since none are playable, there is no recommended setting for 4K.

At 2560x1440, the Low preset averages 64 FPS, which clears the 60 FPS threshold. Medium averages 40 FPS, High averages 37 FPS, and Ultra averages 31 FPS. The Low preset is the only playable option, and it is the best settings per resolution for 1440p.

At 1920x1080, the Low preset averages 72 FPS, which is well above the threshold. Medium averages 45 FPS, High averages 42 FPS, and Ultra averages 35 FPS. The Low preset is the only playable setting at 1080p, and it provides the highest measured average FPS of any resolution and preset combination in the data.

The verdict data confirms these findings. For 2560x1440, the playable settings list contains only Low, with an average FPS of 64. For 1920x1080, the playable settings list contains only Low, with an average FPS of 72. For 3840x2160, the playable settings list is empty.

The Verdict

This PC can run Overpower, but only under strict conditions. At 1920x1080, the Low preset delivers 72 FPS average, which is comfortably above the 60 FPS playable threshold. At 2560x1440, the Low preset delivers 64 FPS average, which just clears the threshold. At 3840x2160, no preset reaches 60 FPS, with the best option being Low at 54 FPS average.

The data indicates that 1080p is the most viable resolution for this combination, but even there, only the lowest quality settings provide a playable experience. Medium settings at 1080p drop to 45 FPS average, which is below the threshold. The margin at 1440p Low is only 4 FPS above 60, so any demanding scene could push it below the threshold, though the database does not provide min FPS data for Low settings to confirm that.

For users who prioritize frame rate over visual fidelity, this system works at 1080p and 1440p with Low settings. For users who want Medium or higher quality, this system does not meet the 60 FPS standard at any resolution. The GPU's low benchmark percentile and the narrow playable window across the measured presets define the practical limits of this hardware combination in Overpower.