Can I Run It?

Instant compatibility check with FPS benchmarks and optimization tips

Overpower
Action 2023

Overpower

30%
Not Recommended Your system may struggle with this game.

Performance

1080p (Full HD)

Low 1080p Measured
72 FPS
Ultra 1080p Measured
35 FPS

1440p (2K / QHD)

Low 1440p Measured
64 FPS
Ultra 1440p Measured
31 FPS

4K (Ultra HD)

Low 4K Measured
54 FPS
Ultra 4K Measured
26 FPS
23.8ms Frame Time
36ms Input Latency
1440p Best Resolution

Requirements Check

Processor
Required 37,513
Your CPU 20,468
Graphics Card
Required 27,382
Your GPU 1,482

Recommendations

Upgrade Needed

Your hardware doesn't meet minimum requirements for this game.

Average FPS: resolution vs quality settings

UltraHighMediumLow
4K Ultra HD 26 32 34 54
1440p QHD 31 37 40 64
1080p Full HD 35 42 45 72

Cell color: green is 120+ FPS, teal is 60+, amber is 30+, red is below 30. Cards marked Estimated above have no measured row and are scaled from your GPU benchmark percentile.

Every measured configuration

1920x1080 High 42
1920x1080 Low 72
1920x1080 Medium 45
1920x1080 Ultra 35
2560x1440 High 37
2560x1440 Low 64
2560x1440 Medium 40
2560x1440 Ultra 31
3840x2160 High 32
3840x2160 Low 54
3840x2160 Medium 34
3840x2160 Ultra 26

Performance Analysis: Overpower on Your System

Measured FPS Breakdown

The recorded data for Overpower on this AMD Ryzen 5 5600 and Intel Arc B390 combination spans three resolutions and four preset levels. The results show a clear pattern: this system is only capable of maintaining smooth frame rates at the lowest settings, and even then, only at 1440p and below.

At 3840x2160, the results are largely disappointing. The High preset delivers an average of 32 FPS, which falls well short of the 60 FPS playability threshold. Dropping to Medium improves the average slightly to 34 FPS, with a minimum of 29 FPS and a maximum of 39 FPS. The Low preset at 4K reaches 54 FPS on average, which is the closest this resolution comes to playable, but still misses the mark. The Ultra preset bottoms out at 26 FPS average, making it the weakest showing across the entire measurement set.

Moving down to 2560x1440, the situation improves, though not dramatically. The Low preset is the only setting that clears the 60 FPS bar, with an average of 64 FPS. The Medium preset delivers 40 FPS average, with a minimum of 34 FPS and a maximum of 46 FPS. High comes in at 37 FPS average, and Ultra drops to 31 FPS. The gap between Low and Medium at 1440p is substantial, a 24 FPS difference, suggesting that the preset scaling has a steep cost on this hardware.

At 1920x1080, the system's best results appear. The Low preset averages 72 FPS, comfortably above the playability threshold. Medium averages 45 FPS, with a minimum of 38 FPS and a maximum of 52 FPS. The High preset delivers 42 FPS average, and Ultra trails at 35 FPS. The pattern is consistent: Low is the only preset that achieves smooth gameplay, and every step up in quality costs roughly 7 to 10 FPS at this resolution.

The data indicates that the Intel Arc B390, with its modest performance profile, is the limiting factor. The CPU, by contrast, has ample headroom in synthetic benchmarks. The recorded FPS numbers show a system that can handle Overpower at its lowest visual settings, but struggles to maintain acceptable frame rates when the graphical load increases.

Similar Performance Alternatives

The database places the AMD Ryzen 5 5600 in the 74th percentile among all CPUs, with an average benchmark score of 20,468. Its nearest rivals are extremely close in performance. The Intel Core Ultra 7 258V scores 20,454, a delta of just 0.1 percent. The AMD Ryzen 5 8500G scores 20,425, a 0.2 percent difference. The AMD EPYC 9454P matches at 20,422, also 0.2 percent off. The AMD EPYC 7713 rounds out the group with 20,363, a 0.5 percent gap. For Overpower, any of these processors would deliver nearly identical CPU-side behavior, meaning the frame rate differences between them would be negligible.

On the GPU side, the Intel Arc B390 sits in the 9th percentile among all GPUs, with an average benchmark score of 1,482. Its nearest rivals are all older NVIDIA discrete parts. The GeForce GT 520MX scores 1,463, a 1.3 percent delta. The GeForce 800M scores 1,460, a 1.5 percent difference. The GeForce GT 625 OEM scores 1,446, a 2.5 percent gap. The GeForce GT 710 scores 1,443, a 2.7 percent difference. The Arc B390 outperforms all of these, but the margins are slim. In practical terms, a system with any of these GPUs would produce frame rates within a few FPS of what the Arc B390 achieves in Overpower.

The combination of a 74th percentile CPU with a 9th percentile GPU creates a heavily GPU-bound system. Gamers considering alternatives should look at the GPU side first. Swapping the Arc B390 for something with a higher percentile ranking would yield far larger gains in Overpower than changing the processor.

CPU and GPU Roles

The benchmark results clearly show that the GPU dominates the performance picture for Overpower across all tested resolutions. The CPU, while capable, never becomes the bottleneck because the GPU's output is so limited.

At 3840x2160, the GPU is almost entirely responsible for the frame rates. The difference between the Low preset's 54 FPS and the Ultra preset's 26 FPS is 28 FPS, a 108 percent increase from the lowest to the highest quality setting. This scaling indicates that the GPU's pixel throughput, rated at 60.00 GPixel/s, is simply insufficient for 4K rendering at high quality. The CPU's 6 cores and 12 threads, along with its 32 MB of shared L3 cache, have no trouble feeding the GPU at this resolution.

At 2560x1440, the GPU remains the dominant factor. The Low preset hits 64 FPS, while Medium falls to 40 FPS. That 24 FPS drop for one preset step is a steep penalty, and it reflects the GPU's limited texture and shading capabilities. The Arc B390 has 1,536 shading units, 48 texture mapping units, and 24 raster output units, a small configuration by modern standards. The CPU's single-thread performance, which scores 882 in the 3DMark single-thread test, is more than adequate for the task.

At 1920x1080, the balance shifts slightly, but the GPU still leads. The Low preset reaches 72 FPS, a playable level. However, the Medium preset drops to 45 FPS, and the gap between Low and Medium remains the largest single-step decline in the dataset. The CPU's multi-threaded performance, scoring 5,659 in the 3DMark max-threads test, is never stressed. The data suggests that even a much weaker CPU paired with this GPU would produce similar results in Overpower.

The scaling between resolutions reinforces this conclusion. At Low settings, the frame rate drops from 72 FPS at 1080p to 64 FPS at 1440p, then to 54 FPS at 4K. That is a 25 percent reduction from 1080p to 4K, which is a modest decline compared to what a GPU-bound system usually shows. The reason is that the Arc B390 is so limited that even at 1080p it is already near its ceiling. The CPU has no influence on the outcome.

How This Combo Ranks

The database ranks this combination at 3,301 out of 3,713 tested combos for Overpower. That places it in the bottom 11 percent of all systems. The ranking reflects the GPU's weak standing, as the CPU's 74th percentile performance does not compensate for the GPU's 9th percentile output.

The measured FPS data aligns with this rank. At no resolution does the system achieve playable frame rates on more than one preset. The 4K resolution has zero playable settings, 1440p has only Low, and 1080p also has only Low. The Ultra preset at 1080p averages 35 FPS, which is less than half of the 60 FPS threshold.

For context, the combo rank of 3,301 means that 412 other combinations perform worse, while 3,300 perform better. The overwhelming majority of tested systems deliver higher frame rates in Overpower. This is not a system built for competitive play or high-refresh displays; it is a configuration that barely meets minimum playability at reduced settings.

The GPU's benchmark score of 1,482 in 3DMark Steel Nomad DX12 is the lowest among its nearest rivals, though the delta is small. The CPU's average benchmark score of 20,468 is respectable, but in a game like Overpower, the GPU dictates the outcome. The combination's rank reflects that reality.

The Verdict

The question is whether this PC can run Overpower. The answer from the recorded data is yes, but with significant caveats. The system clears the 60 FPS threshold at two resolutions, but only on the Low preset.

At 1920x1080, the Low preset averages 72 FPS, which is 12 FPS above the playability threshold. This is the best case scenario for this hardware. At 2560x1440, the Low preset averages 64 FPS, still above the threshold but with less headroom. At 3840x2160, no preset reaches 60 FPS. The closest is Low at 54 FPS, which is 6 FPS short.

The verdict by resolution is clear: 4K is not playable at any setting, 1440p is playable only at Low, and 1080p is playable only at Low. The Medium, High, and Ultra presets all fall below 60 FPS at every resolution. The system cannot handle higher visual quality without dropping below the playable threshold.

The data shows a machine that is strictly for low-detail gaming. If the goal is to play Overpower at 1080p with smooth frame rates, this configuration works, provided the user accepts the Low preset. Anything more demanding, whether higher resolution or higher quality settings, will result in a sub-60 FPS experience.

Best Settings per Resolution

For each resolution, the database identifies the most demanding preset that stays at or above 60 FPS. The results are consistent with the overall performance profile.

At 1920x1080, the best playable setting is Low, with an average FPS of 72. This is the only preset at this resolution that clears the threshold. The Medium preset, at 45 FPS, is 15 FPS short, so there is no room to increase quality. Users at 1080p should stick to Low for smooth gameplay.

At 2560x1440, the best playable setting is also Low, with an average FPS of 64. The margin above the 60 FPS threshold is just 4 FPS, which is tight. The Medium preset at 40 FPS is 20 FPS below the threshold. The Low preset provides a playable experience, but with limited headroom for scene complexity or action-heavy moments.

At 3840x2160, there is no playable setting. The database records no settings that reach 60 FPS, and therefore no best settings recommendation. The closest option is Low at 54 FPS, which is below the threshold. Users with a 4K display would need to lower the resolution to 1440p or 1080p to achieve playable frame rates.

The pattern is uniform across all three resolutions: Low is the only viable preset, and even then, only at 1440p and below. The system's best experience is at 1080p Low, where the 72 FPS average provides a comfortable margin. At 1440p Low, the 64 FPS average is playable, but users should expect occasional dips. At 4K, no setting works, and the hardware simply lacks the throughput for that resolution.