Archeage

The AMD Ryzen 5 7500F paired with the NVIDIA GeForce GTX 1070 delivers a playable Archeage experience primarily at 1080p with Medium settings, where it achieves an average of 96.1 FPS. The data shows that this combination is heavily GPU-bound, as evidenced by the dramatic performance collapse at 4K Ultra, but the CPU’s strong single-threaded capabilities ensure that lower resolutions remain fluid.

Settings Recommendations

The measured FPS rows indicate that Medium settings at 1920x1080 provide the optimal balance for this combo, yielding 96.1 FPS average. This is a substantial 30.8 FPS improvement over High settings at the same resolution, which produces 66.3 FPS, while still maintaining a visually acceptable quality level. Low settings at 1080p push the frame rate to 106.2 FPS, representing only a 10.1 FPS gain over Medium, which does not justify the visual downgrade. Ultra settings at 1080p are not recommended, as the average drops sharply to 44.1 FPS, a 52.0 FPS deficit compared to Medium.

At 2560x1440, Medium settings remain the best choice, delivering 63.7 FPS average. This is barely above the 60 FPS threshold, whereas High settings fall to 41.4 FPS, and Ultra plummets to 30.8 FPS. Low settings at 1440p produce 70.5 FPS, but the jump from Medium to Low is only 6.8 FPS, making Medium the more sensible option. For 3840x2160, no setting achieves a playable frame rate; even Low settings only average 42.4 FPS, and Medium drops to 33.6 FPS. Users targeting 4K should avoid this configuration altogether, as the data shows a hard ceiling below 45 FPS even at the lowest preset.

GPU Role

The GTX 1070’s 8 GB of GDDR5 memory on a 256-bit bus with 256.3 GB/s bandwidth is the primary limiting factor in this pairing. The GPU’s boost clock of 1683 MHz and base clock of 1506 MHz, combined with 1920 shading units, produce a peak FP32 throughput of 6.463 TFLOPS. In Archeage, the GPU’s influence is most apparent when comparing resolution scaling: at 1080p Low, the combo reaches 106.2 FPS, but at 4K Low, it falls to 42.4 FPS — a 63.8 FPS reduction. This 60% performance drop across a 4x pixel count increase indicates the GPU’s fillrate and memory bandwidth are saturated at higher resolutions.

The GPU’s average benchmark score of 12331 places it at the 51st percentile of all GPUs, with its nearest rival being the NVIDIA Quadro K4200 at 12241 (0.7% higher). More relevantly, the GTX 1070 trails the GeForce GTX 1650 SUPER by 1.4% in average score, suggesting the card is operating near the middle of the performance pack. The 3DMark Steel Nomad DX12 score of 1082 is indicative of its DirectX 12 capability, which Archeage can leverage, but the Pascal architecture’s age shows in the 4K Ultra result of 18.2 FPS, where the GPU’s 64 ROPs and 107.7 GPixel/s pixel rate cannot keep pace with the rendering demands.

CPU Role

The Ryzen 5 7500F, with its 6 cores and 12 threads, provides more than enough processing power for Archeage’s MMO workloads. Its boost clock of 5.00 GHz and base clock of 3.70 GHz, built on the Zen 4 architecture, yield a Cinebench R23 single-core score of 3218, which is critical for the game’s main-thread-heavy simulation logic. The CPU’s 32 MB of shared L3 cache and dual-channel DDR5 memory support with 83.2 GB/s bandwidth ensure that asset streaming and NPC AI calculations do not bottleneck the GPU at lower resolutions.

The data confirms this: at 1080p Low, the combo achieves 106.2 FPS, and at 1080p Medium, it still holds 96.1 FPS. The CPU’s multi-threaded strength is demonstrated by its Cinebench R23 multicore score of 22799 and PassMark multithread score of 26825, placing it in the 82nd percentile of all CPUs. Its nearest rival, the Intel Core i7-11850H, scores 24974 on average, just 0.1% behind, while the AMD Ryzen 7 2700X scores 25057, a 0.3% lead. The 7500F’s single-thread performance, however, is its standout feature — a Geekbench single-core score of 2759 ensures that Archeage’s primary simulation thread rarely becomes the limiting factor, especially when compared to the GPU’s constraints at higher resolutions.

How This Combo Ranks

This specific combination of Ryzen 5 7500F and GTX 1070 ranks 1454 out of 1727 tested combos in Archeage, placing it in the bottom 16% of configurations. This low rank is directly attributable to the GPU’s mid-pack performance, as the CPU itself sits in the 82nd percentile. The disparity between the two components is stark: the CPU’s average benchmark score of 24993 (0.1% above the i7-11850H) is far stronger than the GPU’s 12331 average (1.4% below the GTX 1650 SUPER). The result is a system where the GPU consistently holds back the CPU’s potential, which is most evident in the 4K Ultra result of 18.2 FPS — a frame rate that renders the combo nearly unusable at that configuration.

Benchmark results indicate that this pairing is better suited for 1080p gaming, where the rank improves relative to other combos that may have weaker CPUs. The CPU’s PassMark single-thread score of 3841 and 3DMark single-thread score of 974 ensure that even in crowded MMO scenarios, the frame rate does not collapse due to processor limitations. However, the overall rank of 1454 out of 1727 suggests that users seeking higher fidelity or resolution should consider a more balanced GPU pairing.

Resolution Scaling

The FPS drop from 1080p to 4K is severe and reveals the limiting component clearly. At Low settings, the average frame rate falls from 106.2 FPS at 1080p to 70.5 FPS at 1440p (a 35.7 FPS drop), then to 42.4 FPS at 4K (a further 28.1 FPS drop). This scaling is typical of a GPU-bound scenario, as the CPU’s performance headroom is ample — the Ryzen 5 7500F’s 3DMark max-threads score of 6379 far exceeds the demands of a 2014 MMORPG.

The Medium settings scaling tells the same story: 96.1 FPS at 1080p, 63.7 FPS at 1440p, and 33.6 FPS at 4K. The percentage drop from 1080p to 4K at Medium is 65%, which aligns closely with the pixel count increase, confirming that the GTX 1070’s memory bandwidth of 256.3 GB/s is the bottleneck. The GPU’s 8 GB VRAM capacity is not the issue at these settings, but rather the throughput limits. At Ultra settings, the scaling is even more punishing: 44.1 FPS at 1080p falls to 30.8 FPS at 1440p (a 13.3 FPS drop) and then to 18.2 FPS at 4K (a 12.6 FPS drop), showing that the GPU’s shading units and texture rate of 202.0 GTexel/s are overwhelmed.

Measured FPS Breakdown

At 1920x1080, the combo delivers its best results across all settings. Low settings average 106.2 FPS, Medium settings average 96.1 FPS, High settings average 66.3 FPS, and Ultra settings average 44.1 FPS. The step from Low to Medium costs 10.1 FPS, while Medium to High costs 29.8 FPS, and High to Ultra costs 22.2 FPS. The largest performance penalty occurs between Medium and High, indicating that High preset enables effects that heavily tax the GPU.

At 2560x1440, the averages are 70.5 FPS (Low), 63.7 FPS (Medium), 41.4 FPS (High), and 30.8 FPS (Ultra). The drop from Low to Medium is only 6.8 FPS, but Medium to High is a 22.3 FPS loss, reinforcing that High settings are the breaking point for this GPU at 1440p. At 3840x2160, the results are 42.4 FPS (Low), 33.6 FPS (Medium), 22.5 FPS (High), and 18.2 FPS (Ultra). None of these surpass the 60 FPS threshold, and even the gap between Low and Medium is 8.8 FPS, showing that every setting increase at 4K has a compounding negative effect.

FAQ

Q: What is the best settings preset for this combo at 1080p?

A: Medium settings provide the best experience, averaging 96.1 FPS. Low settings only add 10.1 FPS more (106.2 FPS), while High settings drop to 66.3 FPS and Ultra falls to 44.1 FPS.

Q: Can this combo handle 4K gaming in Archeage?

A: No. The highest average at 3840x2160 is 42.4 FPS on Low settings. Medium drops to 33.6 FPS, High to 22.5 FPS, and Ultra to 18.2 FPS, all below playable thresholds.

Q: Is the CPU or GPU the limiting factor in this configuration?

A: The GPU is the clear bottleneck. The Ryzen 5 7500F ranks in the 82nd percentile of CPUs, while the GTX 1070 ranks in the 51st percentile of GPUs. The FPS scaling from 1080p to 4K follows pixel count increases, indicating GPU limits.

Q: How does the Ryzen 5 7500F compare to its nearest CPU rival?

A: The Ryzen 5 7500F has an average benchmark score of 24993, which is 0.1% higher than the Intel Core i7-11850H (24974) and 0.3% lower than the AMD Ryzen 7 2700X (25057).

Q: How does the GTX 1070 compare to its nearest GPU rival?

A: The GTX 1070 has an average benchmark score of 12331, which is 0.7% higher than the NVIDIA Quadro K4200 (12241) but 1.4% lower than the NVIDIA GeForce GTX 1650 SUPER (12504).

Q: What is the overall rank of this combo in Archeage?

A: This combo ranks 1454 out of 1727 tested combinations, placing it in the lower 16% of all configurations tested for this game.